Wireless

Does anyone know how to protect your WLC from Multicast/Broadcast storms coming for LWAPPs? I have enabled "config network multicast global disable" on WLC cli but this only protects you from wired storms. I have upgraded the OS to 4.1.181.0 didn't w...

I'm trying to load the new WLC software. It's 36+ meg. The WLC only allows TFTP transfers. The file is to large for TFTP. Please don;t tell me the only way to load this file is XMODEM???

Well basically my situation is as follows: we are using 40 Cisco AIR-AP1242 around 3 building sites for our school ( Ramsey Grammar ) which all are secure WEP and working fine however we would like to have two locations open and Virtual LAN direct to...

Gentlemen,Does the Cisco outdoor wireless unit support dynamic routing (e.g. RIP or others) to do the load balancing between leased line and wireless connection.I am looking to confirm if the outdoor unit has the routing features to apply this scenar...

We purchased two 1300 APs for outside. There is a new release for the image that we wanted to use so, we have the latest security updates. We downloaded, logged onto the access point just fine, but the image never took. After four hours with a direct...

I have both interfaces setup as lag, connected on different switch cards on the same switch.In the switch logs, it is returning errors that the host is flapping. Is there something I have configured incorrectly, or is that expected behavior due to th...

I work in an office where the wireless routers are so close together that now, while I am trying to document each router and their MAC addresses I cannot differentiate which is which. I was wondering if there is a way to hardwire into each router and...

Hello,I have a setup configured fairly simple, I think. We have a 4402 WLC at our corporate office. We also have 6 1131's split into two deployments at different offices. We have a common SSID structure across all of them (corporate and guest). Corpo...

Hi, I wish to connect LWAPP AP on a remote office. The controler will be reachable through on OSPF L3 network. Moreover, I wish to define my WLAN VLAN on the remote office so as the WLAN client have a remote IP and are switched by the remote switch.A...

Sir Can I from cw2000 to find the router serial no or machine no?

somebody knows tthe steps to configure the WLC 2100 with a microsoft radius server for authentication?

We have a WLC 4402 and there are a lot of messages in the log. How can I find out what the messages means ?F.example :Jul 20 07:07:25.076 apf_80211.c:1923 APF-1-PROC_RSN_WARP_IE_FAILED: Could not process the RSN and WARP IE's. station not using RSN (...

I have a potential customer that is purchasing a 4404 WLC, and 80 Cisco APs. They also have a few oddball APs, including HP420s and Proxim 4000s. The customer wants to know if there is any sort of minimal management/configuration/reporting that can b...