Wireless

works function WLAN Override in controller WLC6?, we have tried it and it does not work, is a software problem?

All, I have a WiSM module in a 6500 switch that I need to configure. I need to start the configuration of this, but Im not sure where to start on it and how to go about the configuration of this module. Does anyone know of a configuration guide for t...

Hello , I am using AP 1231, to connect a my handheld to wifi lan.AP is configured for WPA security and Brodcast key rotation set to 700 seconds.My handheld is getting deauth after key rotation interval, ( i am not sure if this feature is causing deau...

We have multiple 4404 controllers in the same mobility group. Because our controllers are placed into different buildings and our common SSID is set on WLANs on different VLANs/subnets, I would like to ensure "inter-subnet roaming" occurs in case a c...

I recently installed a 4400 for a customer, everything works fine except that the access points randomly disconnect from the controller, reboots and connects again. (5-10 minutes between reboots)Any suggestions on why this is happening?(i was on cons...

I have installed a Controller 4402 with version 4.0.217.0, APs 1010, with server of authentication RADIUS of Microsoft (IAS), using 802.1x with PEAP and MS-CHAP-v2. I have a problem in the first authentication, it is not only that he is slow, is that...

I have a Cisco 3750 switch with the following VLAN's2 - Engineers3 - Automation Dept4 - AN Other Company5 - Guest AccessI have an 1131ag connected to the 3750 and I have setup a dot1q trunk on the swithchport that connects to the AP.http://www.cisco....

Does anyone know how to protect your WLC from Multicast/Broadcast storms coming for LWAPPs? I have enabled "config network multicast global disable" on WLC cli but this only protects you from wired storms. I have upgraded the OS to 4.1.181.0 didn't w...

I'm trying to load the new WLC software. It's 36+ meg. The WLC only allows TFTP transfers. The file is to large for TFTP. Please don;t tell me the only way to load this file is XMODEM???

Well basically my situation is as follows: we are using 40 Cisco AIR-AP1242 around 3 building sites for our school ( Ramsey Grammar ) which all are secure WEP and working fine however we would like to have two locations open and Virtual LAN direct to...

Gentlemen,Does the Cisco outdoor wireless unit support dynamic routing (e.g. RIP or others) to do the load balancing between leased line and wireless connection.I am looking to confirm if the outdoor unit has the routing features to apply this scenar...

We purchased two 1300 APs for outside. There is a new release for the image that we wanted to use so, we have the latest security updates. We downloaded, logged onto the access point just fine, but the image never took. After four hours with a direct...