Wireless

Hi,I need to UPG AP from IOS mode to VxWorks. I format the flash file system and delete all binaries. Then I found on Cisco web,that come back to VxWorks is not possible.OK.I start recovery procedure...but:- .I download last TAR IOS file c350-k9w7-ta...

I'm running WLSE 2.9.1a and I'm playing around with the real-time reports. I'm looking at a single AP and am able to get realtime graphs for Packet Statistics for E0 and dot11radio0 but I'm getting nothing for CPU or Client associations and radio ut...

Hi All,A wireless problem that is relatively unknown.SYMPTOMSWhen your Windows XP Service Pack 1 or Service Pack 2 (SP1 or SP2)-based Wireless Zero Configuration (WZC) client computer is in the proximity of two wireless access points, and one of the ...

I keep getting this log entry over and over "Interface Dot11Radio0, Station AP-name, Mac add Associated KEY_MGMT[NONE]" By the way I took out my AP name and MAC add for security reasons.WHy does my AP keep associating to itself?Thanks

I would like to connect two Cisco Aironet 1310, one which is connected to a wired LAN(Root) and the other as a non-root. The objective being wireless devices will connect to the LAN through these two aironets.Can anyone reply me with a sample config ...

Is there a way to have a an AP on multiple maps within Location manager? We will have coverage across our Campus including some outside coverage. Besides the interior floor plans I'd like to have an overall coverage map of campus showing all APs (...

I have got an AP1121G that I connected to the eth0 port of a PIX501.While doing traffic, I notice that I get a lot of CRC input errors on the eth0 int of the PIX and that the communication to the AP slows down considerably.I have tried different sett...

After implementing a WDS with PEAP authentication via ACS 3.3 all clients now re-key every 28 seconds. ACS has been set up to force a re-key every 9 minutes and if an AP is removed from the WDS, clients go back to a 9 minute re-key. All AP's that reg...

Hello,I don't want wireless clients to be able to see each other, so I have configured PSPF in the APs, but this only prevents this situation to the users that are associates to the same AP. I know that I could configure 'switchport protected' in the...

Hello,I want to know if it is possible to broadcast multiple ssids in the beacon packet so that the client can choose one of them depending on his role.We have a customer that wants to assign different ip ranges to users but without having to configu...

Has anyone set up 1310br in a PMP configuration. I have talked to TAC about this and all I've received is to make sure IOS is current. This lately is the first thing out of TAC. Always an IOS issue. Well I've done this and I still can not pass tr...

I was wondering if anyone knows what this error is. I have a few 1230 802.11b access points, After upgrading to the latest firmware 123-2.JA I have found 2 of the units the status and radio light stay green. What is the cause of this? I am still seei...

hidid any one test the printer billing in BBSM5.3?i can't make it correctly.any help

I know you can configure multiple profiles with the Aironet desktop utility and then click Activate on the profile to use it.However, is it possible to configure a profile which is always used when the computer has been restarted? How it works now is...

Dear sir,I am running RF link between 2 locations on Cisco Aeronet modem. The link runs perfect with normal latency, when there is not any broadcast. But when it is connected to PCs through server, broadcasts start coming. And the latency goes very h...