Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

hi all ,i have aps 1242 with wireless client associated and an ap1242 in workgroup bridge mode associated too , can the ap in workgrp mode roam between different AP1242 ? if yes is there some special conf needed ?normaly the client decide wich ap to ...

a.diot by • Level 3
  • 794 Views
  • 2 replies
  • 0 Helpful votes

My friend has a house which has a guest house about 300 yards down in a hill. I tried even the best Linksys products but had no luck. So thinking about using some high end Cisco Wireless solutions. Does anybody have any suggestions? I would really ap...

paymaunj1 by • Community Member
  • 543 Views
  • 1 replies
  • 0 Helpful votes

Hello All, I'm hoping that someone here on the forum can help me with a possible solution.I have a small network with a Cisco 1200 AP. Is it possible 2 have 2 SSID's on the AP? One for guests and one for internal LAN users?My thought was to create 2 ...

hnhoang33 by • Community Member
  • 1450 Views
  • 6 replies
  • 0 Helpful votes

We have a WLAN Controller 4402, with firmware version 4.0.206.0. The ports are connected to 2 separate switches. 'ap-manager' is on port 1, and 'ap-manager 2' is on port 2. The wireless network is running fine when both ports are connected. However, ...

I have a 1231 WAP that I just continually reboots. Here is the error it gives right as it reboots: %SYS-5-RELOAD: Reload requested by LWAPP CLIENT. Reload Reason: FAILED CRYPTO INIT.I may have put the wrong image on it, I didn't want it to be in ligh...

9ccameron by • Community Member
  • 698 Views
  • 1 replies
  • 0 Helpful votes

hi,i have a ap 1200 configured as wds ap and other ap configured as normal ap.i want to configure ap as dhcp server.the question is; i configur dhcp just in wds ap or in all ap.

Hi allMy company want to manage all Autonomos APs of branch-offices from head-offices.Link from branch to head-offices is 256 kbps.May I use WLSE for this scenario ?Help me, plz.Thanks

HiI m running a centralized WLAN environment. Controller: 4402APs: LAP1242AGI m broadcasting 2 SSIDs, where one is configured for WEP and the other for WPA/AES. This all works fine, and Clients can connect and there are also no disconnects.Now I inst...

Hello all;I have the following setup 500express switch which connected to a backbone 3560 switch thorugh interface gig 0/1 and an access point 1121 connected to fa 0/5the wireless connectivity is working fine but I have the folllowing problem, random...

I currently have a 1200 AP providing DHCP for wireless users on a single floor of a govt. bldg. Wireless and wired connections are on different subnets. My AP is issuing IP addresses to not only the wireless cards, but the wired as well. How can I ma...

rdunbar30 by • Community Member
  • 806 Views
  • 2 replies
  • 0 Helpful votes

I have a 1200 series AP and need to reset it to defaults again. Easy right? I have 3 of them, 2 went without hitch but the third is not reseting using the mode button. I can hyperterm in but still need a username and pass to do anything. Anyone have ...

lcsokoboji by • Community Member
  • 757 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card