Wireless

I understand that to be able to use mGRE tunnels, all that is needed from the AP is to have IP connectivity. If the AP connects to a port on a switch, and that port is on VLAN 196, for instance, will the following setup allow me to connect to that V...

I am just starting to setup Fast secure roaming in our 1200 ap wireless network.I have a few questions I want to get answered before I spend to much time on it.1. Radius authentication? Does the radius server have to authenticate with LEAP or can we ...

I am having trouble trying to locate the location to download or review the latest software for the 4400 WLC. Does anyone know where I can see what is available for this box. Thanks

Why can't I statically assign a channel on a non-root 1300 Bridge? I keep losing connectivity to my root bridge (which I can assign a channel)every time it scans for the least congested channel.Thanks in advanceChris

Hi, I have installed Cisco Aironet 1310 as access point for local wireless network. Clients having Dell laptop with inbuilt wireless network adaptor are connecting to it successfully but the problem occurs with clients haveing Cisco 350 wireless netw...

We recently deployed Cisco 1231 APs (cisco AIR-AP1231G-A-K9).The software version is Cisco IOS Software, C1200 Software (C1200-K9W7-M), Version 12.3(4)JAAs soon as these APs are powered on, we immediately lose connectivity to our existing Symbol APs....

Hi,I have installed a Cisco 1310 Aironet Bridge/AP as an Access point for local wireless network connectivity. Every thing is working fine. When I connect Dell Laptop with built-in wireless adapter, it connects successfully. The problem occurs with t...

I'm trying to get RADIUS authentication working using Windows 2003 IAS and an AP1200, client is an AIR-CB21AG with latest drivers (2.1). Can anyone point me to a "how to" guide or advise how to configure each component to get it all working?Thanks in...

Does anyone know what the guidelines are for number of clients talking to one 1231 b/g AP? I know that a lot of it depends on traffic volume per client. However, I am trying to get some idea of a rough guess. I currently have 15 clients on one AP a...

We have 4 1200 AP's, 3 are master, 1 is repeater. The repeater goes down every 27 minutes with warning "too many missed beacons".Close to the repeater is a client-PC, which is roamed to the parent, and this one has a signal of 63%.The repeater has an...

Recently we've noticed an increase in ad hoc networks in our buildings, likely a result of new laptops with the internal Intel wireless connections that make it so easy. I'm wondering, can these ad hoc networks cause inteference with our WLAN? These ...

I am trying to find a white paper on Redundant WDS (layer 2, 1200 series AP) but having no luck. I am pretty sure you are able to have a redundant WDS but just want to clearify with a white paper. Any URLs?

I am using a 1200 AP in a clinical area for wireless access. It only runs 802.11b. I have about 25 clients in this area connected all the time. We just went live with this yesterday and the wireless devices keep dropping the connection to the AP. ...

I am trying to configure AP 1200 MAC adress filters in allowing a list of MAC addresses, but the list is not being applied. How can I configure the restriction "deny any" in a AP 1200, so I can deny any MAC address but the ones allowed in my list.