Wireless

I am installing AP1131's for a customer. I usually mount them horizontally below the ceiling tile. My customer wants me to mount them vertically above the ceiling to drywall. My question is mounting the AP1131 vertically vs. horizontally changes the ...

I have a WLC 4400 running ver 3.2.150.6. The LAP is a 1242AG-A-K9. I am getting this error message on the wireless controller log when I try and use my Symbol 9060 RF units the message is: WEP Key decrypt error. Station MAC Address is 00:a0:f8:ba:b5:...

Hi Members, can you help me find a way for Configuring only One Controller completely and then synchronising the Other(s) with "One Click", not using the granular Configuration Templates? Regards, Michael

Hi All,We have couple of Cisco 1200 APs.what username and password I should use to login thru GUI with level 15 access to these WAPS.. We have following AAA configuration in palaced in these WAPsaaa new-model!!aaa group server radius rad_eap!aaa grou...

1) How many simultaneous users are supported. Am using the US standard in the US.2) Can adjustments be made to the amount of power the transmitter is using? Such as reducing the foot RF foot print?

My scenario parametres:1. Two large (1km sq) mixed outdoor and indoor WLANs need to be deployed.2. It's two power plants with many small and large buildings and machines indoors and out.3. WLAN primarily to be used with Symbol handhelds in the area i...

Hello,i am not able to chaneg any settings in Aironet1232AG when type configure terminal using CLI or Hyperterminal it syas unknown command? how can i configure the AP,configure terminal ^% Invalid input detected at '^' marker.regardsKamath

Hi Folks, i converted about 30 AP?s 1230 from Autonomous to LWAPP Mode, using Conversion Tool 2.05, 6 AP?s at a Time. I used the output file for pushing the List from WCS to Controller. About 25% of AP?s could not be authorized by the WLC, because th...

HelloWe have several 4404 controllers that each support 100 antennas.When I follow the documentation for using multiple ap-manager interfaces (our controllers have 2 fibers to one switch and 2 to another one) it says that I have to create 3 additiona...

we have two 7920's and seen that we could not get them to authenticate to AP though both ssid and the encryptions on both the 7920 & AP were correct.both phones could not authenticate and all settings were correct.it wasn't until we reset the phones ...

Hi allI have a 3200 MAR sitting on my desk right now and quite a headache: I would like to make an LWAPP antenna use the MAR router and another WiMC configured as a universal workgroup bridge and yet I have to make everything work together. I can mak...

I am working on a system to provide 500 lightweight access points, my issue is that each one of these access points needs to be powered and i am assuming POE as my primary option which leads to the 3750 switch, which i understand now have the WiSM mo...

Hi,We have:6 1130AG - 12.3(8)one ssidall 1130s are on the same vlanencryption mode wep mandatoryDo we need WDS to allow IBM thinkpad to roam freely between 1130s?Thanks in advance.

Could anyone tell me about the fips kits and its use?Wen i used config tool for NAC and AP this kit comes as option to choose.Thanksswamy

Hi,i'm trying out an 887w router but can't for the life of me figure out how to get the wireless running 802.11b. Before you ask why its so i can get PDAs connected. thanks in advance Charlie