Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On page 10-4 of the Cisco Wireless LAN Controller Configuration Guide (Software Version 4.0) under the section about Client and Network Load Balancing is the following note:"Client load balancing works only for a single controller. It is not operate ...
Hi,A client ask me the following:"I have a problem, I need to authenticate employees to our wireless network using their domain user and password, but they all have portable computers that doesn't belong to my domain". I have one SSID using PEAP to a...
ACS SE controller 4402we configure wireless solution and integrated with microsoft database(serv. 2003 Active Di.)and i can log on using password and username .Presently we are using ACS as a certification authority.We installed the certificate on th...
Is there a way in the WLC to have two separate radius servers defined so that one is for EAP and one if for MAC authentications? Any help is greatly appreciated.
Hi all,after installing WLC, WLC can't adjust 802.11a channel eventhough AUTO RF was set. So All APs adjust it's channel value with 149 and 1 (maximum power level).Please let me know how can i check?Regards,John.
Dear Stephen,I want to what product is suitable for the following situation?User will use their laptop to assign the internet by the following situtaion.1. They will go to a web portal to select their internet service provider and login the services....
Using the AIR-LAP1242AG lightweight access points, I have recently observed that the base radio MAC addresses appear to increment with each SSID/WLAN that is advertised on them.I have not noticed this on the AIR-LAP1131AG access points.Is this suppos...
HelloWe deployed a wireless lan for customer. There are 3 floors with 4 APs per floor and connections drops happen. Users complain that, when they work in a fixed place sometimes they lose connection and when they change place, there is more chance t...
hi,i am facing a starnge issue. My wireless works all of fine with MS IAS as radius server dot1x authenstication. But the problem comes when i add an interface on controller from vlan 1 (i.e.same of where my Radius server exist) After this interface ...
I want to know how to assign permenently and staticaly multipple ip addresses to single wireless network adaptor. I could do it in advance mode in TCP/IP property window, but the second ip adress never remains there after restarting the machine. Kind...
I need to know (if anyone have in practice). What will be maximal distance in ideal conditions with Cisco 1200 series AP for outdoor point-to-point connections in WGB mode with high gain directional antennas ?
We have a wireless project and the customer needs to build a scope of work for Cisco wireless solution. Are there any articles that help me to build this paper?THANX.HASSAN
I have 5 1131ag access points connected through a 6012 powerdsine midspan to provide POE. 2 of the units power up ok but the other 3 do not enable the radios. The 2 that are working are showing as drawing 8 watts but the other 3 are only showing 4 wa...
