Wireless

I have one location that I'm having problems getting the laptops to associate to the 1130AG ap's. I'm using EAP-FAST w/ TKIP authenticating through a WLSM to ACS for AD authentication. When the laptop comes up it will initialize and then fail on asso...

Hi All,We have a WLAN setup with 1 AP 1230 assigned as a WDS, and the 16 APs configured as Infrastructure AP. Off late, I am experiencing a problem where all my clients are getting disconnected frequently. I have checked the logs and the logs indicat...

I have upgraded my 1200 AP to a 802.11b/g radio and now I am experiencing a lot of drops by my clients. When I was running just my 802.11b radio I had some issues with my clients, but after setting my channel to a particular one instead of "LEAST CON...

I am trying to switch from The internal ACS user database for password authentication to an ACE Key FOB server with the subject line config and I get Ext. Database Failed. It works for my routers w/ TACACS but not with the WiFi.EAP FAST <--> WLC <-->...

Hello,I have a question about configuration for external antenna. In the setting of Radio0-802.11g i can enable parameters for external antenna. I need to enter a value in dB: Antenna Gain(dB)?Which value can i put?I'm using AP 1231G with an external...

We're starting a wireless deployment with 1240 AP's and have run into a bit of a problem. It was decided that we label all of the AP's with the last 6 digits of their wireless MAC. Is there any way to find that information out of the box? I've consol...

Hi, I am have problem with Bridge and switch 3550, the port is Down and Up randomly.Anyone can help?.config is in the belowinterface FastEthernet0/23 switchport trunk encapsulation dot1q switchport mode dynamic desirable spanning-tree portfast.This a...

Hi,I am using Cisco ACS and Cisco AP AIR-AP1231G-A-K9. They are configured so that client can be authenticated using PEAP. However, as soon as join the AP to WDS. It stops working and no clients can now be authenticated by PEAP.000066: *Mar 1 00:52:2...

Hi All,My customer's environment is using WLAN Controller and some Cisco APs with ACS 3.3 using PEAP MSCHAPV2. They prefer to only allow the clients whose PC has logged in Windows Domain using Domain Account to associate the "PEAP enable" SSID.At pre...

I am trying to find out if I have setup my WISM and I have 802.1x setup within my infrastructure. And say I want to control which SSID a user is allowed to access via Radius Authentication. Is there away to send a reauth command to move a device from...

HelloI would like to install a connection with root and a workgroup access point. On the site of the workgroup bridge access point I have an other switch where I need 3 different vlan. Is it possible to configure different vlan over this connection o...

We are using a Novell server as our DCHP server and we are trying to configure option 43 for our 1130 access points. There are two fields in the Novell implementation; data and key, but we don't know what values go in the respective fields. Has anyon...

Hi, Im trying to set up a Wireless network. I have got a aironet 1310 in the AP mode with a 12 dB antenna in a campus, In some areas the signal its not strong.Now a Decide to use some linksys WAP54g in the repeater mode. I dont have any security apli...

Hi,I have a customer that has a WLSE currently with version 2.13. When we are browing a device, we try to access its configuration (which I think internally triggers a telnet/ssh session to the device, a sh run is issued and the output is collected a...