Wireless

Hello, If you have a separate voice vlan across a wireless bridged network, how could you configure qos to put the entire voice vlan in priority over the data vlan ? Thanks.

Dear all, We are using Cisco AP1231 Access Point in our office to provide the wireless LAN and we are using LEAP for authentication. Now, we would like to use WPA (with PEAP authentication) for the new notebooks. Is it possible for a single AP to use...

We are receiving error that BBSM transaction history is full and we do not know how to clear. Can anyone help?

I have Cisco AP 1220B running IOS 12.2(15)JA and want to upgrade to 12.3(8)JEAI type "archive /safe /overwrite /reload tftp://xxx.xxx.xxx.xxx/c1200-k9w7-mx.123-8.JEA" I get the error message "% tar checksum error" "ERROR failed to open archive file" ...

I have three Aironet 1200 WAP's that I recently upgraded from VxWorks to IOS. After the upgrade two of the three will not broadcast their SSID. They will also not let anyone connect to the access point. I reset them several times, re-imaged them with...

Hi, What exactly is the use for the command "ip dhcp snooping packets"? Do I need this? We had a problem today with users pulling a dhcp address. They were authenticating to the AP with no problems, but no luck pulling an address. FYI - these are con...

Can I configure the 1200 for WPA2?

Does the WebAuth Passthrough script on a WLC 4402 4.0 validate a users email. Does it simply accept any email address bogus or not and log it?

Hello all!I have an AP with multiple SSID/VLANs. The management of the AP is via VLAN 1. I also have VLANs X and Y binded to SSIDs VLANX and VLANY respectively.I have created a DHCP pool that I want to bind to only SSID VLANY users (not VLANX users)....

Hello,About 4 months ago, we installed 12 Aironet 1200s in our building (numbered 10.0.201.101-10.0.201.112). We have 104 and 112 acting as RADIUS servers and, at one point, they were allowing their clients to obtain an ip from a particular scope on ...

Hello...I am planning a wireless site survey with the requirement for the WLAN to support both VoWLAN and location based services. I have read the design guides from the Cisco web site and see that 'monitor' access points are recommended to increase ...

Is there a manual or page that describes what these alarms and error messages mean? I get the blurb from the WCS or Wism, but I don't know what they mean sometimes. I try to search Cisco and other websites, but I don't get a whole log of useful infor...

Scenario:Cisco Wireless Lan Controller WLC4402-25-K9Cisco AireOS Version 3.2.150.6APs 1000 Series Windows 2000 server SP4 (standard edition) with AD, Certificate Services, IIS and IAS.On this controller, we have created 2 WLANS. One to grant access t...