Wireless

I have a need to set up a guest wireless network for some class rooms in our office. We have about 50 new users coming through every week and the administrator doesn't want to have to create 50 new guest user accounts each week. I'd still like to hav...

Hi.I have been reading the guide "Configuring ports and interfaces in 4400" and I have one dude about how can I support more than 48 AP in 4400.The guide says "The access point then joins the controller using that isolated VLAN with Layer 2 LWAPP. Al...

Ok, I have been going crazy for 3 days now trying to get 2 Aironet 1310 AP/Bridges to connect the Root Bridge and Non-Root Bridge using Microsoft CA, Microsoft RADIUS and network EAP. I don't know if I'm just not getting it or what. The Non-Root brid...

Assumed that we have a wireless network infrastructure for a building that contains 4 floors and each floor has two different VLAN with one cabinet (switch support PoE). In addition the data center was built by a different building and connected by f...

Hi,can I use 2 Antennas (2,4 GHz) on 1 Cisco 1242 Access Point, working at the same time.I know, that you can configure the AP to use "Diversity", but it seems that in this case only one antenna is used by the ap at the same time.Can I configure the ...

Does anyone know if there is going to be a patch for the DST change for the WLSE, or if there is just a way to change it command-line, what that would be.Thanks,Pat

This topic has been kicked around quite a bit, but I still can't find the answer. I have a Aironet 1200 with the internal 802.11b radio and an upgrade 802.11a radio. I've defined two SSID's, one for each radio. The status page shows both radios as up...

I have a client that is looking to deploy 1300 series APs to provide wireless access for both internal users and guest users. They would like to allow guest users access to the internet without WEP or security while forcing internal users to use WEP/...

I have 2 1131AG APs located on 2 different floors sharing 3 SSID's in 3 different Vlans.Should I set one of them up as a repeater ? How do I do that under the web gui?

any experience (good or bad) using this? Thanks-W

I have been doing site surveys the "old fashioned" way for quite some time.I am interested in how the survey is performed utilizing the new lightweight AP's.Mainly, how do you determine AP location if there is no way to configure the AP itself?Do the...

We have a Cisco Ap1200 and can't get in because the person who set it up forgot the password. Need to know if there is a way to get the password back.

We have Intermec 751 mobile handhelds and three WLAN controllers. A 4404-100, 4402-25, and a 2000-6. The 4404 & 2000 series are running 3.x WLC code and the 4402-25 is running 4.x.We're using the same SSID & WPA-PSK on all three controllers, and the ...