Wireless

I try to authenticate to the wireless network (AP1200), but my Aegis Supplicant says "Connection failed: unable to associate"Debug of the AP with options: debug dot11 events debug dot11 station connection failuregives me_____________________*Mar 1 01...

Hi,I have been tasked to configure an 877W for a customer. It is a remote site and is to VPN in to the main site were the ACS is located. Users on the main site are authenticated into AD via ACS (on the Wireless). Is this possible for the remote site...

Does anybody know if Radius Web auth is supported with MS IAS radius server or is it working with cisco ACS only ?Thanks

When I display location readiness in WCS, I notice that a lot of the areas were red.Do the red areas indicate that more APs are needed for "location readiness"?(Assuming that "location readiness" means that it cannot and will not track devices in the...

Can anyone help? All I want to do is enable 802.11b support on my Cisco 877W. My 802.11g clients can see and attach to it no problems. My 802.11b clients cannot see it at all. I have tried all sorts but nothing has helped. My config looks like this: ...

From time to time i loose connectivity to a non-root bridge from a non-root repeater bridge. When i goto to the non-root repeater bridge I click on the log entry for the lost non-root bridge and select disassociate and connectivty is then restored to...

Hi,I am tring to set up a Cisco WLC 2006 with EAP-TLS + WPA.Everytime I try to log in to the network my wireless card gives a message saying " validating user", but nothing else happens.I cannot find any manual for configuring this. Can anyone perhap...

My problem is after I changed the AP mode of my 1030 AP from local to bridge mode, the 2006 WLC won't detect it anymore.How to restore the 1030 AP back to it's local AP mode?Thanks

Just unboxed a brand new location Applinace and following the setup steps. when I get to where I have to configure the ifcfg-eth0 file I put in all the changes and try to save and I get a E212: Can't open file for writing error message. I can not get...

I was wondering if anyone has ever used the aironet 1200 with bluesocket? If so what do I need to do in order for the aironets to be placed behind bluesockets protection?Would I use a route-map on the switch the aironets connected to or something els...

We are using a Cisco 4402 Controller, and testing methods of web authentication. We are also testing a Meru controller - so our tests are geared towards the pros / cons of each.With Meru, we are able to point the web authentiction page to a RADIUS se...

When the 1100 and 1200 radio's recive "deauthenticate (2) not valid". The radio knows its not a valid deauthenticate but still shuts down and restarts eny way. How do I stop the radio from shutting down and restarting when they recive the "not valid"...

Hi, I can't find anywhere the list of product include in the 6500 wireless bundle WS-C6504-E-WISM and WS-C6509-E-WISM. Does someone now ?Thanks in advance.

Hello Friends,I have configured Cisco877W for wireless access, and it is working okay for most of the wireless clients (i have tested HP nc6120 with Intel and also IBM), but for HP nx 6110 does not working, i.e: those wireless clients cannot see the ...