Wireless

I have a custom WinCE 4.1 platform that does not have the ActiveSync service manager built into the kernel. Is there an alternative way to install the Aironet 350 software (WinCE-PCMCIA-LMC-272.exe) on this device? It has CF card access and NE2001 su...

I want to establish a secure wireless bridge (with a root bridge and one non root bridge). I can set in the non-root which is the MAC address of the parent, but how can I set in the root bridge with MAC is the non-root one ? I want to avoid other non...

I have 3 1200 APs total. One configured as an Access Point, the other two as repeaters. I have the latest firmware on all 3. I have been noticing that periodically the access points "reboot". The system uptime varies from many hours (8-10) to less th...

Does somebody knows how many simultaneous wireless client the WLC 4404 support?Thanks

Hy to everibody.I have a 1310 Wireless Bridge, configured as a "Root bridge with client" and on VLAN-1 I have 2 different SSIDs with two different security policies.This configuration seems to be working.I read that this mode is a misconfiguration.So...

How do I configure a Cisco 1242 WAP if I do not have a Wireless Access Controller. The unit has recieved a DHCP address from my network, but I cannot telnet nor web into the device. The Cisco getting started guide says that you can revert it to auton...

Hello.IEEE802.11,1999 Edition standart define reason code 0x8 - Disassociated because sending station is leaving (or has left) BSSBut what exactly it mean?For example there are two station AP1(non root) & AP2(root), on AP2 in log we see "Interface Do...

Anyone using QoS to regulate use of resources consumed by guest users? Any rules of thumb/guidelines/examples?

How do ACL's work on the WLC?I am using 4.X ver of software for the WLC with LWAPP APs, like there is any other way.I have a guest VLAN setup and when I apply an ACL to it, it stops responding. I would think that that ACLs work like ACLs, but that is...

Hi there,for testing purposes, I would like to force an Aironet 1230 AP to SENDwith a specific WLAN data rate (say 48 MBit/s). Unfortunately, I amunable to do that.A Linksys AP for example is able to to do it. Its webinterface has anattribute "Tx Rat...

I am having trouble with a CAS/CAM configuration. I have been testing a guest tunnel configuration with 2 cisco wireless lan controllers in the past. That has worked when I used a firewall on a PC, with 2 NIC's to forward traffic for the guest tunnel...

Dear all,I've configured our new AP and encountered the following problem.When people from other offices come to my office and try to connect to my ap they pick up the wireless network but they don't get an ip address in our range.I can't find out wh...

Hi everybody.We are using Catalyst Express switches and air-1121G for a wlan network covering a hotel. When we set the smartport-setting on switch to "access-point" users cannot move from one access-point to another. Setting the smartport-role to "ot...

Hi Sir,I would like to use Radius-based Vlan access control through WLAN as the number of SSID map to wired VLAN is limited to only 16. I have an ACS 4.0 But i wish to use AD to manage my user profile. How can I set the following to enable Radius-bas...

HiI have a test enviroment with 2 ap1030 and i want to make a 5ghz bridge link with these two aps. this should be possilbe. but im not able to get it worked. i also didnt found a good documenation for this configuration.do i need to make both aps in ...