Wireless

Hi,I've an existing WLAN network of about 15 APs running WPA. The number of APs is expected to increase to aboute 30-50. As I would like to have better RF & AP management and also rouge AP detection & suppression, I'm looking at getting either gettin...

hi all,I could not get the WLC 2006 to communicate with the AP1010. My configuration is straight forward. WLC2006----CE500----AP1010DHCP Server (192.0.2.222) also connected to the CE500. The DHCP server can ping the WLC2006 and likewise.configuration...

I selected 3 AP1231s running 12.3(2)JA to do a AP Radio Scan;Job shows ended one hour ago, but the radio data is still old. Site Survey Wizard - AP Radio Scan 3154 12:43:56 12/29/2005 No Yes - 12:43:56 12/29/2005 12:54:16 12/29/2005 jaarons The Job R...

I am thinking to setup a wireless network (Cisco Airespace controller 4100) using EAP-PEAP for authentication. We have a Microsoft 2003 server running IAS. My understanding is that a server side certificate is needed at the MS IAS server. I don't kno...

Hi everybody.¿Where can I find an estimation of the coverage ranges that can be obtained with the AP 1200 and omnidirectional antennas of different gain?Thanks

OK I walked into this huge warehouse and did not have the necessary tools to do the a site survey on such a space. I did get measurements though. So I am looking for insight as to what antennas i can use with the AP1200, and how many I might need for...

I was wondering if it was possible to manually set configs to default on these AP's(other than through the controller) or log into them via telnet or etc.....

Set up a wireless network using a 4124 Wireless Controller and AP1020 and AP1030 access points. The two AP1030's are at a remote office with a 6Mb pipe between the two offices. I am unable to associate the AP1030's to the controller. The AP1020's hav...

The ISA2000 FW service will not start on the BBSM53 I have installed at a client premises.I had it working fine, issuing DHCP addresses, authenticating guests and allowing browsing and VPN traffic to the Internet.. the World was a good place....Then ...

Hi,I have a WLSE with 2.12 version firmware and AP 1210 serie with 12.3(7)JA firmware. I have several site location with 2 radius server (a main and a backup). When I turn off the main radius server, to make test, all the AP go to the backup to regis...

Hi,I would like to know if it is possible to pass trougth vlans on 2 1310 wireless bridges.I have a switch1 --> 1310 --> 1310 --> switch2. I want to pass vlans from switch1 to switch2.How can i do this?regardsLuís Rodrigues

Me again... I have an other issue...I'm trying to receive the mac-address for all theconnected clients to a Cisco access-point (Cisco1130) by SNMP.The best way to do this seems with the cDot11ClientConfigInfoTabletable.(CISCO-DOT11-ASSOCIATION-MIB OI...