Wireless

Hi,Does anyone know of any good books, white papers, URL's on wireless 802.11a/b/g design guides for large multistory buildings? I'm talking about buildings that are 60 stories plus.Thanks!Steve Monsey

AIR-LMC352 is now obsolete. Could anybody suggest alternatives with 16bit bus, external antenna connectors, and WPA?

I have installed a BBSM53 at a client site. It is primarily used for guest Internet access. However, the company in question obviously want to stop guests accessing websites that may contain offensive material.Natively the BBSM53 does not support URL...

HiI want to secure the communications between 2 Br1310 acting as point2point bridges. That is, I want to make it as close as impossible for anyone except eachother to talk/listen/whatever the radiotraffic inbetween.I have done this:ssid <long random ...

I am using an 851W configured with WPA-PSK and TKIP. I am getting an awful lot of messages in the log stating that a client has disassociated because it was leaving the BSSID, then the client immediately reconnects. I have duplicated this behavior wi...

Hi Does anybody has the same issue that when you want to make an Wireless Client Report you cant select the end Date to 2006?regards Bernhard

Here is the info about the 1100s AP I have in the office:Product/model number: AIR-AP1120B-A-K9Part number: 73-7886-04Basically I was trying to upgrade the system software from 1100-k9w7-tar.123-2.JA2 to the latest version of c1100-k9w7-tar.123-7.JA2...

Im doing an install with a couple dozen 1230 B/G AP's and one of the requirements is to have the user first go to a default disclaimer page before going to the internet. I cant think of any way to do that other than with BBSM. Is this the case? thank...

Hi, We currently have a 350 Wireless Bridge on 2.4 Ghz. We are currently trying to connect AP1231-G-A-K9 on 2.4 Ghz point to it. Can this still work if the 350 Access on 802.11b while the 1200 on 802.11g?

Hi all,I'm trying to connect two buildings using a point-to-point wireless connection. I'm not having any luck getting a non-root BR1310 to connect to a root BR1310 using open authentication with EAP. My non-root bridge keeps throwing up the error: I...

Ok as the title says, I must have taken a wrong turn somewhere while upgrading the IOS and well, I'm at the 'ap:' prompt. When I issue the 'dir flash:' command here is the output:ap: dir flash:Directory of flash:/2 -rwx 3555 <date> private-config3 -r...

I currently have 6 1200 series ap's and I’m using MAC Authentication to allow connection to the Wireless. Everything is working fine but every time I need to enter in the MAC address for that client I have to add it on every AP. This is very time con...

HiI want to configure 2 1300 Bridges as a point2point-link between two buildings. I want the radio link to carry 3-4 different vlans.Each bridges ethernet-interface will of course be configured as a .1q-trunk and will be connected to a switch which i...

I am using Wireless LAN controller with software version 3.2.78.0. My question is the purpose/function of the "AP Group VLAN" config option under the WLANs section. The on-line help is useless in explaining "what this is" and "when to use" matters. M...

I'm starting a wireless project and would like to know what hardware I need, at this point I have the following HW1130AG, WLSE,We have a 6500 with an IDSM2 blade, what kind of security can the IDS provide for my network?Thanks