Wireless

Hi,Currently building a L3 roaming Wireless LAN within a test environment. Currently have a Cisco ACS Appliance for AP authenication. Is it possible to integrate the Appliance into Active Directory in order provide PEAP authentication to the Laptop c...

I have got a 1200 access point. Want to test it so that clients connected are directed to radius server for authentication using EAPAny lead will be very much appreciatedthanks

I have a user with an Intel 2200BG wireless client (driver ver. 9.0.1.9) that keeps on roaming while the user stays behind his desk. Nearest AP (G-type 1200 - 12(3)4.JA)is just around the corner. The other AP's are 30 meters away or on another floor....

Our wireless voice network currently uses 4 1231 AP's and 1 1100, and were setup by a consultant company. They instructed us that when a new 7920 phone is put into service that the MAC needs to be added to the list in Adv. Security. I have been doing...

I am looking to find the maximum number of clients a 1200 AP can handle when configured in Workgroup Bridge Mode.The actual 350 WGB can only have 8 clients off of its Ethernet port via a hub/switch. Is this true for the 1200 WAP? I am looking for thi...

Where are the WLSE 2.12 Release Notes? I can only find a regulatory compliance doc about the WLSE 2.12, and I need to read about the bug fixes!

I work for a reseller and am trying to put a demo box together that will include WCS.I am using WCS 3.0 and VMWare 5.0 on a Windows 2000 Advanced Server.I had worked fine on this server before, but doesn't seem to work on the virtual server on the sa...

Anyone have a sense of when 7.x Pix OS is going GD? I see 7.02ED has been out since about 7/20.

Hi,I have some barcode portable DOS terminals in which i have installed LMC352 client cards. So, i have to work with last known good firmware v4.25.30.In those Wlan that have static wep data encryption enabled, after some usage some cards stopped wor...

Is wireless connectivity obtained at the point where two signals meet or must the signal actually reach the recieving antenna?

Hi Everyone,I have a current problem when a client will roam to a repeater AP and will lose layer3 connectivity. I am currently looking into the 50% overlapping coverage as the possible problem. I am able to access the repeater via telnet and http wh...

I have the Aironet 1200 AP setup to authenticate and perform authorization for the CLI via TACACS. That is working fine.However, the web interface is failing "ip http authentication". (Slight caveat - it works for a local user in the local AP DB - it...

Quick one, what do the three LEDs on the 1232AG access point indicate? I assume its the usual status, activity, etc. but in what order? The documentation does not include this info!Thanks

Anyone out there have an istallation guide for one of these? I have acquired one for home use and need to default it so as I can set security on it. Any help would be appreciated.

Looking for documentation to upgrade an AIR-AP1231G-A-K9 with an AIR-MP21G-A-K9 radio running IOS ver c1200-k9w7-tar.123-7.JA.tar to become an LWAPP AP to connect to an 4400 series controller.Thanks in advance,DTA