Wireless

Hello,I have a WLAN which is managed by a WLSE. Is it possible to give a certain CLI (command line interface)from the WLSE to all the AP's ?I have forgotten to put in a command, and since all the AP's are configured in the same way, it could be very ...

Is there any way to drop the wireless connection automaticlly when a client docks a computer into a wired dock. The wireless radio and wired port are on different VLAN's. I do not want them to be multihomed. I can use different profiles if they bring...

I am looking at buying and installing a pair of 1300 series bridges at a new remote site we are taking on. My question is can I get away with using a 6 pack 734 coax cable to connect the bridges to their power injectors or do I have to use individual...

first time installing Wireless LAN need some documents to understand the wireless lan installation

I have a WLAN setup and am using LEAP for authentication between all devices. Everything seems to work good, but have always wondered this. I can only get the non root bridges to associate to the root bridge if I set them to Non-Root w/ Clients. Shou...

All,Just purchased a CB21AG-A-K9. Downloaded the latest drivers from the web site. But, when using both the Cisco Site Survey Utility as well as Netstumbler, I am not getting noise levels reported. Nothing in the documentation seems to indicate that ...

Hi folks,I experienced a few days ago, onde thing regarding AP 1100.I´ve tried to upgrade de IOS version, but in the middle of upgrade, the system crashed, and right now, I can not upgrade by Command line, or even GUI (GUI is unavailable). So, the le...

i have the IOS converted software from VxWorks and i currently have software version 12.2(11)JA3 loaded and i want to upgrade to the newest version or at least a later version so that i can enable WPA. when i try to use the HTTP upgrade page within I...

HI,I have got about 40 odd AP's in my network.I am using LEAP with Cisco ACS.In the client utlity i am not able to see Cisco AP name and its IP add.Initially i use to see this info on my client machine.I am using CB21 A/G cards.Can someone help..

I'm integrating a WLAN with Funk Steel Belted RADIUS, RSA SecurID ACE, Cisco 1230 AP and Odyssey Client.All the componete were installed following vendor instructions, verified several times.The Odyssey Client begin Auth, wait for Keys and reset the ...

I just ran the ADU 2.1 installation program to upgrade my ADU from v 1.3.0.9 to 2.1. After the upgrade I rebooted, and before the login prompt appeared, a "User Interface Failure" popped up, saying "The Logon User Interface DLL cscogina.dll failed to...

Hi allWe use WLSE for the configuration of the AP (1100g, 1130 and 1200). Since the IOS 12.3(4) version, we have to use a guest vlan (open, broadcast SSID and no mac address restriction) with our "old" radio networks (no broadcast, and mac address re...

Hello,Can anyone recommend a suitable tool?Fairly new to WiFi and require to perform a site survey to ascertain appropraite equipment deployment based on SNR, RF interference levels, etc.Tool can be shareware or commercial product?All help appreciate...

I have several 1220 802.11B AP's that I am upgrading from VX Works 12.01-T1 to IOS for adding G radios using the CAC Tool. During the upgrade process, an error occurs saying the AP doesn't have enough memory. Has anyone seen this message before, or d...

I have three VLAN/SSID interfaces configured on several 1210 APs (with in the same subnet). I have configured WDS with infrastrucure and client groups on one access point and set the others as infrastructure clients and it is working properly. Howeve...