Wireless

Hi there.I have setup EAP type authentication using MS-PEAP V2, everything works fine. The issue is when using PEAP, users must authenticate before network connection is established. However, this introduces another issue, I cannot for example, push ...

having trouble enabling Client Tracking. If I check the radio button for “Enable Client Tracking on all WDS Devices”, I get no errors but find that Reports>Wireless Clients gives no details even after several days. If I change the drop down to “Clien...

I am using a Aironet 1231 with firmware 12.3(4) and I have enabled Multiple BSSID. I have two SSIDs that I am broadcasting that I would like to have guests access. Each SSID has it's own VLAN (1 and 2, 1 being native). When I connect to the first SSI...

Has anyone tried lowering this parameter? And if so, did it help? I'm considering lowering it on nodes that are on the edge and that have a lot of radio retries. Does anyone have an opinion on this?

The many Aironet350 AP that I am administering would suddenly drop all clients and output the below log: Started driver for port "awc0" Stopped driver for port "awc0" Started driver for port "awc0" Stopped driver for port "awc0" Anyone has any experi...

I have done several of these installs in the past, trying to get a new setup for one of my customers. I usually configure them before taking them to the site, even test them to see if they are associating before hand. So I started with two 1300 bridg...

Hi there,I'm trying to setup home wireless network using AP 11G.The problem i'm facing is my client could not get any ip address at all.Can someone help me with the configuration on my AP??Tks

If I'm not mistaken, one WDS AP with its radio interface turned off can handle up to 60 APs, is this correct? I have a wireless network that consists of 95 APs, all in the same subnet. I've setup two APs dedicated solely for WDS. MY problem is that a...

Hello ,We are having the problem that Our Wireless Client intermediately reassociates with other access point in our Network, which result in the disconnection of the Clients from the network.Please suggest some solution, as we have tried to reduce t...

Why did Cisco remove NTP support with no notice? ie it's not documented in the release notes that I can see. The "upgrade" removes any reference to "ntp server" thereby requiring further config changes to support it.

I have a Dell laptop with a build-in wireless card and it associates to the AP via the IAS but I do not get an IP address.Can some one tell me what to do.Cristian

hello.we tested with cisco AP1100 with my laptop (intel wireless card).at first,we tested linksys AP with wep-key. it is great.at second,we tested CISCO AP1100 with wep-key.but, it is fail.we configured it, below.ap1200(config)# interface dot11radio ...

I'm running Suse9.2, and have good success with generally getting my miniPCI cisco WLAN working with any non-LEAP based WLAN. On the same machine (a Dell D400) I also have a window2000 running ACU (v6.1.002), which authenticated with our company LEAP...

Due to mobility concerns I have the need to send video over wireless access points to clients. The application however isn't really a streaming or multicast video...its just a web page with hundreds of *.wmv video files served up via a web server. So...

Can someone point me to a link for setting up voice vlan ? we're trying to use Cisco wireless phone 7920 and would like to know about setting up the voice vlan. Thank you very much.