Wireless

I am setting up a wireless network at home that will be integrated with my current LAN architecture. See the attached diagram for details, but essentially I want to place a wireless access point inside of a secure LAN and allow only specified users ...

Will IOS 12.3(2)JA support MAC Authentication on the 1310?Corey

I have an AP 1100, and want to enable so encryption on the transmission. In the past I have used MAC address authentication, and want to augment the security. (Understanding that authentication and encryption security isn't the same thing)With this,...

I'm hoping someone can help. I currently have (2) 1200's. One is working fine with an 802.11a and an 802.11g radio. The one we have on the first floor is the exact same hardware but when I assosiate on the G radio I cannot get an ip address from our ...

Anyone have experience with wireless print servers, particularly in an enterprise environment? Any details regarding brand, model, authentication and encryption used would be helpful.

I just want to know if Wireless Speed is shared or dedicated.Say, If I have 54Mbps (Wireless-G) and 10 users. Will it be 5.4Mbps per user or 54Mbps per user?

Does anyone know where I can find documentation on configuring PEAP authentication on Aironet software version 12.2(13)JA? Thanks.

Hi everybody:I want to use PEAP in my wireless network; I understand that I need a digital certificate to my server that is in a CS ACS 3.2 with radius for the first phase and establish teh secure tunnel. My question is, can I use the same CS ACS to ...

I have a new WLSE appliance and while setting up WDS, the 3 AP's I have on my segment stopped working.I have my AP's on the 192.168.1.X network and the WLSE is on the 10.1.1.X network. I know you cannot route WLCCP packets from AP to AP, but from wh...

Hi:I submit that wireless routers only route IP and specifically do not route Appletalk. Appletalk support in wireless routers amounts to proper bridging between the 802.3 port used exclusively for inside wired connectivity and the 802.11 port used e...

I have 6 AP's with G radios and would like to maximize # of users due to density issues. I configured 2 SSID's with 3 different channels on 3 AP's (1,6,11). (2 sets of these for 6 total).Using indoor wall patch antennas.Right now I am using DHCP to a...

After upgrading ap1200b point to AP1200-Cisco-IOS-Upgrade-Image-v3.img then to c1200-k9w7-tar.122-15.XR2.tar I set 2 vlans with static wep. The virtual dot11radio0 interface is down and an error occured during reset. I have rebooted, and the same. Wh...