Wireless

This error has recently started to show up in the logs of our closet switches. (3500's and 3550's) It is only associated with clusters that include a powered switch servicing AP1200's. What should I look for? Is it a concern? Thanks Tom

Why do I recieve the following error from WLSE 2.7.1 when scheduling a firmware job to upgrade from 12.2(13)JA2 - 12.2(15)JA? I have no problems upgrading to this image from a command line using a TFTP server. Here is the output I receive from when I...

I configured EAP-TLS for the wireless LAN in the Novell 6 environment. However encountered a problem on the ACS with Novell NDS. Attached is the error messge, any advice on how to overcome ? I have generated the server key and the client key from Win...

I have several Novell 5 & 6 servers running pure IP. All of my Desktops run fine with a wired NIC. All of my XP wireless laptops run fine with either a CISCO 350 wireless card or its own internal NIC. The problem I have is with 2 models of laptops. O...

I use two extenal onmi antenna at ap1200. But how long limit to fix between two onmi antenna? Any one can help me ! Thanks!

Hi there,All leds of my AP turned amber. this means "Boot failure" according to this document: http://www.cisco.com/en/US/products/hw/wireless/ps430/products_installation_guide_chapter09186a00801cfb52.htmlBut how can I get through it?

Hi,Is there any in depth documentation on the usage of ACU as the site survey tool?By looking at the site survey option, it is in passive mode. However, once I clicked on setup, it bring me to the active mode.How can I intepret the options available?...

Hi,I encountered lots of SSID mismatches in the received statistic using my ACU.What could be the reason for this?On the AP, I disallowed SSID broadcast. The client is configured with the known SSID to get connected to the AP.Thank you.Delon

I have been told that there is a maximum of 30AP's for WDS. is it possible to create more than one "domain" using a single lan for management IP's and multiple wireless vlans (different ip subnets for each vlan in each domain).

Hi,I setup the AP 1200 as the local RADIUS server in order to run LEAP on my wireless client as my customer does not want to spend more money on a RADIUS server.I manage to configure it and LEAP is running fine. However, I can have more clients to us...

Hi All,I am setting up some 1200 APs w/ LEAP authenticating to ACS for RADIUS. My Aironet client can log in with a username and password from the ACS database. The problem is that I can't see this user logged in at the ACS server. Under "Reports and ...

This forum does say getting started, so don't bash me too much on my ignorance.I am looking to find out exactly what I need to setup a LEAP infrastructure. (this will be just a lab test environment).I have a 1200 AP and both Windows 2000 and Windows ...

How much bandwidth does a single AP WDS domain consume to send RM data to a WLSE? I have a large WAN with slow speed links and a Cisco rep said that it would take 1Meg! Find that hard to believe. What's the actual number?Thanks!

I'm trying to use a SJphone on my desktop [and PDA],behind a PIX 515. I'm getting an error message that says "NAT/Firewall:blocked". How do I configure the PIX and/or my PC and PDA to allow me to use the SJphone. Thanks.

Hello-First off, please forgive the lack of knowledge in this post...This is pretty much my first experience with anything Cisco-related.I had a Cisco 1200 AP v12.2(13)JA4 and a Cisco BR500E v8.80 dropped off in front of me with instructions to set t...