Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I have a 1200 series AP that I was able to access via terminal connection last week. It has not been configured for use yet. Today the status LED is amber and the radio LED is red. Every time the unit is powered down and up the same LEDs appear. The ...

francisjad by • Community Member
  • 673 Views
  • 2 replies
  • 0 Helpful votes

I have a couple of 340 AP devices. One of them would not allow clients to access the network any longer. When using the web management interface the AP Radio interface is not even present now. I have upgraded the firmware to 12.04 and attempted to re...

gparrish by • Community Member
  • 800 Views
  • 2 replies
  • 0 Helpful votes

Can a 1310 bridge operate also an Access point? I know the 350 series bridges could not work as an AP, but in the Cisco documentation it states that the 1310 is a wireless bridge/AP. If it can work as an AP can both the bridge and the AP features be ...

skilambi by • VIP Alumni
  • 1086 Views
  • 3 replies
  • 0 Helpful votes

Hello,I am trying to run wireless video over our wireless link and with the Cisco 1200 running at 54Mbps vs. 11 mbps. The 11 out performs the 54mbps by a wide margin. The AP is running IOS 12.2(13)JA. I will try upgrading to JA4.Any thoughts.

tlchant by • Level 1
  • 802 Views
  • 2 replies
  • 0 Helpful votes

hello can any body tell me about VSAT (very Small Aperature terminal) and DSS(Direct Satellite System)complete solution and toturial about that....or any web site that provide me complete solution and understanding.....thank a lotirfan aslammirfanasl...

Dear Sir,I would like to know whether AIR-AP1230B-A-K9 comes with any power inline injector such as AIR-PWRINJ3 or I have to quote additional part number which is AIR-PWRINJ3=?Thanks.Delon

c.ong by • Level 3
  • 784 Views
  • 2 replies
  • 0 Helpful votes

Hi all, please i need help,I have installed an Aironet 1100 and i use it with dhcp, my configuration is the following:ip dhcp excluded-address 172.28.13.1 172.28.13.149ip dhcp excluded-address 172.28.13.155 172.28.13.254!ip dhcp pool prueba network 1...

elihcaros by • Community Member
  • 1635 Views
  • 3 replies
  • 0 Helpful votes

According to Cisco Doc, you can run WPA & CCKM simultaneously. has anyone tried? What encryption did you run? TKIP only?there are many things that Cisco say you can do this and that... but it's not always true... i guess they omit the phase 'in the w...

uggie by • Community Member
  • 703 Views
  • 1 replies
  • 0 Helpful votes

I am using a Cisco 350 series access point and I keep having problems with my users picking up other SSID's and attempting to connect to them. I am using 128 bit WEP encryption on my SSID and there is some form of encryption on the rogue SSID's. They...

I have setup WPA on a Cisco 1231g AP running 12.2(15) firmware. I cannot seem to connect with a laptop and Cisco 350 card. If I disable WPA it works. Are these cards compatible with WPA?Thanks.

tcggg0 by • Level 3
  • 991 Views
  • 2 replies
  • 0 Helpful votes

AP1200 IOS 12.2(15)JA,in a non-WPA/CCKM implementation, What is the difference between WEP: Mandatory with MIC and PPK - and Cipher: TKIP + WEP128? Does the TKIP + WEP128 Cipher package provide PPK and MIC? The documentation for this is a little spar...

joevincent by • Community Member
  • 1099 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card