Wireless

can an aironet 1200 be bridged with AIR-AP350 wireless router. I would like to have AIR-AP350 on the 13th floor of the building and the Aironet 1200 on the 9th floor. I would like the aironet 1200 to connect to the AIR-AP350 without the aironet 1200 ...

My ip filter is configured as follows:Default Action: Block AllDestination Address: 0.0.0.0 Mask: 0.0.0.0Source Address: 192.168.1.31 Mask: 0.0.0.0Action: ForwardI apply this to the FastEthernet port (Incoming and Outgoing)When I do that I lose conne...

Hi all,I have my Wireles ISP using Cisco Aironet1310 AP/BRsand I want to run AAA server to control the access to my system...My Question is is possible to use ACS2.6 which already exist to maintain the Security and control the access to my Wireless I...

Hello, I have a more then 100 AP's on my network.I want to manage all the AP's with one USER/PASS that allowed on my ACS.I try to mark the " Authentication Server if not found in Local List" on Security page and to configure the RADIUS Server on Serv...

Does Cisco have an antenna designed to mount above a drop ceiling? We have a client who wants the antennas out of sight.Thanks-Mike

Where can I get the great information on upgrading our 45 Access points to the latest firmware. Do I have to upgrade to each new level of firmware or can I go from 11.06 to the latest?ThanksTim

In my other post re: 350 bridge, I cited some logs from the non-root bridge, which is the one that is failing. From the root bridge side, this is the log entry:Deauthenticating <non-root bridge>, reason "Inactivity"Not sure why it's deauthenticating ...

Have had an aironet bridge in place for approx 5 yrs. Recently (1 year) replaced both 340's with 350's. At that time, updated 12.00T firmware to 12.03T. Recently (2 weeks) one side of bridge failed. Got replacement unit. Downloaded new image file BR3...

Our WLAN(350 and 1200 ap's) reports:"Possible rogue AP 000000000000 detected: Reason "0""What does this mean ?RegardsJohann Folkestad

Our wireless network has been outstanding. However, I have had two scenarios where a communication closet UPS starts to die, restarts the Cisco 3548, or 2950 Switches off and on etc, and the connected Access Points on those switches get corrupted. Th...

Hi!I'm configuring some wireless links using 350 bridges. Every link is working good, but I have one link between 2 350's that is not working. The antennas are in line of site and the 2 bridges are configured the same away...running the same ios code...

hi all, thanks in advance if anyone could advise me on this issue. Or is there any confirm bug for it firmware or any patches that we can use to patch it if it a known fault? Have been using AP 340 for more than 2 yrs and recently found that the APs ...

I just installed a WLSE 2.7 Appliance with 3 AP1231G APs and when I use the Location Manager, each AP shows up Red and an error message states that the AP's are not set in infrastructure mode. On each AP under the SSID Manager, I have the "Set Infras...

Hi all,I know this issue has been raised before but I haven't seen if there is a resolution to this.I got a 1231 AP last week and it worked fine for a day, tried to boot it up this morning and it wasn't happy - gave me a red and orange light. When I ...