Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

can you pls give me a design implementation of a user with a aironet 350 card associating with an AP 1200 far away from ,that i am not able to connect from my home.pls give me solutions as to how a home user would connect by using a wireless adapter ...

Among LEAP, MIC and TKIP, which one is responsible for encrypting wireless data ?I think LEAP only authenticates users; MIC ensure no one alter the packets. TKIP makes it hard to figure out the keys1. Is wireless data (if someone sniffers each packet...

ewang by • Community Member
  • 1552 Views
  • 5 replies
  • 0 Helpful votes

I attended a Cisco class that focused on implementing an 802.11b network. In that class we were told that as a rule of thumb the data rate can be tied to Signal/Noise Ratio. With a ratio above 10+dB, you can expect an 11Mbps data rate, 8+db = 5.5 Mbp...

dvlewis by • Community Member
  • 974 Views
  • 4 replies
  • 0 Helpful votes

I currently have several 1200 APs with both a "secure" vlan and "guest" vlan.The secure VLAN requires WPA with an ACS server providing authentication.The problem: A client associates and authenticates to the secure vlan, and will then randomly loss t...

dcrudele by • Community Member
  • 624 Views
  • 1 replies
  • 0 Helpful votes

We are a boarding school and have installed 3 AP350s and 68 AP1200 access points in our dormitories and classrooms. We are implementing a laptop program and want to cut off access to our network from 10:00 PM until 6:00AM the next morning. We use Net...

jmerricks by • Community Member
  • 3235 Views
  • 9 replies
  • 0 Helpful votes

Dear Sir,The following URL mentioned other third party Cisco compatible client product..http://www.cisco.com/en/US/partners/pr46/pr147/partners_pgm_concept_home.htmlCan they support LEAP and TKIP/MIC too?Thanks.Regards,Delon

c.ong by • Level 3
  • 496 Views
  • 1 replies
  • 0 Helpful votes

Hi,I'm new the the Cisco AP1200 so please forgive if I ask dumb questions. Anyway...I want to only allow auth users on our network. I need some central way of controlling who is allowed and rolling it out to the APs. I think MAC access lists would pr...

Hello there!I'm running an AP1230 with the latest IOS.I wish to enable WEP 40 or 128 with TKIP. Mandatory!If I'm not wrong I have to enable WEP Encryption and then enable Per Packet Keying PPK.However I'm not sure if PPK is pure original TKIP compati...

gilmo by • Level 2
  • 930 Views
  • 1 replies
  • 0 Helpful votes

On AP1100 I see increasing output drops on "sh int dot11radio0" output. There's nothing wrong operationally. I see this with any user associated to the AP. What may be the reason for this?Regards.