Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
folks, Are there any known issues with using EAP authetication as well as mac address authetication???would the access-point autheticate both and only them let the client associate with itself or either.is it possible to create groups of users in ACS...
Hello,The release notes, and users guide is available. When will this be avialable for downloaded. Does anyone know?
Folks, We have a couple of G radios access-points (1200 series) in our building, I have been asked to use WLSE to secure them. I have a few questions:1) Would the WLSE detect a B radio or an A radio? if so how, because all the access-points are G rad...
Folks, Can i change the ip address of wlse from the console without running the recovery cd. Any advice would be highly appreciated.Thanks,
Dear SIr,To setup LEAP authentication using ACS, the client needs a supplicant such as the ACU to run LEAP independent of OS. Cisco AP will be the carrier of the EAP message between the client and the Radius server sitting between the client and the ...
Our Cisco 1230 access points are in a separate VLAN from our wired switches. We just purchased a WLSE, should it belong to the same VLAN as the AP's or does it really matter? Thanks.
I am running into an issue establishing a cross sub-net connection. I am hoping that some one has "been there, done that" Thanks for sharing any lessions learned.Background:My notebook hosts a PCM350 wireless nic and a Realtek RTL8139 wired nic. IPs ...
If I set my 1121G radio to support all data rates my "b" client is unable to associate. Is there something special I need to set on the radio to allow a "b" client to associate while all data rates are supported? If I disable the "g" data rates my cl...
hi,i am managing access point 1230 cisco via snmp, i want to know how can i rach to the wab interface and not the radio interface, because i have acces only to the radio interface( series350client, radioclient,...) i want to have information about th...
What happens when different businesses work together in the same building and all of them have a wireless network (802.11b or 802.11g)? Can a user in one floor detect an AP at the previous and next floor and try to connect to it, in other words, the ...
I have a laptop running Windows XP (fully patched) using ActionTec onboard 802.11b wireless card connection to a AP110 with firmware of 12.2(13)JA3 SSID broadcast is set to "No" and WEP 128bit. Authentication is "open". Most other settings are factor...
All:IOS (tm) C3500XL Software (C3500XL-C3H2S-M), Version 12.0(5)WC3b, RELEASE SOFTWARE (fc1I'd like to test 802.11x authentication using a CAT 3548 and Steel Belted RADIUS in a test lab.Question: Does the IOS on the switch support this?If not, which ...
I have a Cisco Aironet 350 PCI card and internet connection via a cable from an antenna on my roof. This means that I depend on the computer that has the PCI card installed to gain acces to internet, printers aso from my other computers.I want to rep...
Apple recently released Airport 3.3 for Mac OS 10.3 (Panther). This release provides support for WPA with Macs using either Airport or Airport Extreme wireless NICs. So far I have been completely unsuccessful associating my PowerBook equipped with an...
Has anyone tried install a Verisign Certificate on ACS 3.2 appliance. We installed the 10 day trial with no problem but when we tried installing the "real" certificate we get "Invalid Key file format error"
