Wireless

Is there any known configuration to configure aaa authentication for wireless Access points, in the manner "aaa authentication ppp" is used for dial-in customers; or can that command work with wireless APs??

I want to setup HOT SPOT with Cisco So Can I use 350 bridge as an Access Point with 12dbi Omni directional antenna? can we configure ETSI based bridge to 100 mW power?

Can any confirm that SSH or AAA NEW-MODEL doesn't work with Aironet IOS?I checked the aironet command reference and can't find anything...

I purchased a Dlink DWL-G800AP Wireless 802.11G repeater as a low cost portable solution to extend the range of our Cisco 1200 Series Access Points (802.11G versions). The Repeater is able to see our Cisco 1200 AP without issues, but it just doesn't ...

i have cisco bridge 250 working in root mode. On station details and association table some IP addresses of the associated station look like IP Address ?10.3.2.19 What "?" means ?

Hello all,I currently have a Wireless LAN implemented in one of my buildings using Cisco 350 Client adapters and AP's. I have a user that is about three blocks away from the nearest AP and I was wondering if anyone had any ideas on how I can make/buy...

I just want to know whats the effect of using a splitter on aironet 350 right/primary port....will the signal decrease and by how many db?.thinking of using patch 14db antenna on both point...appreciate help on this...

What is the diff b/w VALNs created in a access point and that in a switch where an access point is terminated? which one is better

Does any one have a problem with Toshiba portege R100 on connecting to WL Cisco AP-350 it is associated with the AP but does not get IP address, after a few play with network configuration it work ok but next time of reboot the same problem again, al...

I am just beginning to look into wireless for in house use. I am looking for a simple recommendation or direction I should start looking. My primary need is for a Software Training room with 14 node than constantly need to be broken down and moved. I...

I'm in the process of configuring an Aironet 1200 with IOS 12.2(13)JA1. LEAP & MAC Authen are enabled along with dynamic WEP keys. Let's say I rotate WEP keys at 10 min intervals. This should generate a Passed Authentication message of " Re-Key OK" o...

Hi all,Do you find out the complete list of error and log which could happen on these device running IOS?Does it exist a document like "Sytem MessageGuide" as we have with IOS on router?Thanks in advance for your answer,Regards, Frédéric

Hi,I've setup EAP authentication (PEAP) to authenticate WLAN client on an AP. The AP is connected to a switch where the port is not configured for 802.1X. On this switched port I enabled, in multi-host, 802.1X to authenticate also the AP as a client,...

I was browsing though the Cisco site and found out the the end of sale for the Cisco 350 Bridge Series. We employ Cisco 350 Series Bridge 12.00T on all our wireless sites for interbuilding connectivity.Can somebody recommend me the latest Ciso Bridge...

We've got about 120 aironet 1100s in use. They're all configured for the use with leap "authentication network-eap eap_methods"Since we're using all aironet 352 Pcmcia cards we don't have any problems.Now we are in the negotiation phase for new handh...