Wireless

Here is the question. What is the difference in a AP350 when you set the radio to optimize for range vs. optimized foor throughput? We have a customer that has some "cheap" laptops that will only associate with the AP's if they are set for throughput...

I have access point running on 12.2(13)JA3 and a gateway 450 with an Inter pro/wirelss 2100 and all is fine when using LEAP. Once I change to PEAP and install the certificate it fails to authenticate and the wireless keeps failing/authentication/disa...

Hello!We are bound to deploy a large WLAN at a school here, both for student and employee acess. We have a wired system based on 802.1x and PEAP so we are going to keep PEAP for the WLAN as authentication mechanism. The AP's will probably be 1230 and...

I have a customer with more than 1800 350 series APs running VxWorks. They want/need to upgrade to IOS, so WLSE seemed like a no-brainer. However, they had had a demo unit at some time in the past and wrote it off as garbage. Consequentially, they ar...

Hello, I just installed a Netgear MR814v2 DSL router at a location. They are using a Aironet 4800AP to connect all clients internally. Can this AP bridge or repeat with the Netgear so they can use it at their default gateway? I can't find anything to...

When sending encrypted data, where in the packet is the Transmit Key identified so the recipient can decrypt the packet?

Hello I just added a new PC to a wireless network controlled by a Aironet 340 AP. The AP can see the new PC (with a PI21AG PCI card) but the new PC is not an address via the DHCP server on the router. If I manually add an address to this PC I can pin...

Hello,Today I set up a config with 4 1200ap's and 1 cisco acs for leap authentication and accounting. This works fine.However I would like to finetune this with the result that each user can only be authenticated once. This to prevent several users f...

Can I use only 1 external antenna AIR-ant4941 on ap1220 to make it run?

Since turning on accounting on a VxWorks 12.03T WAP1200, I am receiving the following message in the event log:2004/03/25 10:41:01 (Info): Acct jobEntry time out on NULL entryI was unable to find anything on the TAC website. Any ideas what this is an...

We are currently pilotting two Cisco 1100 APs with two Centrino laptops having integrated 11b adapters.Although the two APs are configured similarly, we are not able to successfully roam between them. We start off associated with one AP, and can ping...

Our company has a centralized IS department. We go out to the remote sites, do a site survey and install a wirless network. But over time the layout of the building may change and that in turn will cause a change in RF reception. I am looking for a s...

If an AP 1200 is set up to support both standards but there are no 802.11b clients connected to the AP, do you get the maximum 22mbps 802.11g throughput?I have read "Capacity Coverage & Deployment Considerations for IEEE 802.11g" but it doesn't answe...

Hi,is it possible to use an AP to detect rogue AP's or adhoc networks, e.g. by configuring it in such a way that it logs all wireless traffic it 'sees' (regardless of SSID, encryption, etc.) ?In other words, to use it as a wireless sniffer?tiaHerbert

I recently upgade my Aironet 1200 to the G radios and have noticed that whenever a b card associates all connections drop down to the lower speeds. I can somewhat understand why this is happening, but has anyone had any experience as to supporting bo...