Wireless

I have 2 existing LMR 600 (50 ohm) cable runs to an antenna tower that are currently vacant. Can I use these in the place of 75 ohm coax to support an Aironet 1400 bridge?

What PDA wireless adapters would you recommend that works well with Cisco 1200 AP. Security includes TKIP+WEP128 and Network EAP. Thanks.

Hi,I've read in some Cisco document that you should not have more than 30 APs in the same WDS domain. I have over 100 APs in a campus wide installation that are all on the same management (native) vlan. So they are all in the same IP subnet. What's t...

Hi all,Is anybody has tested the interoperability in 802.11b between WGB AP350 and ORINOCO AP-1000. (with ORINOCO as Root bridge because it seems that WGB can not act as root bridge).Many thanks for your help.--Ludovic.

I have 6 of the new A/B/G client adapter cards (PI21AG) that are running on a Windows 2000 & Windows XP (3 of each). The access points I am using are Aironet 1200 APs with the G radio upgrade kit installed running IOS.The issue I am having is this. T...

I just received a new AIR-PWRINJ3 for my AP350 (someone lost the original one) and when I plug it in I get power, but nothing on the ethernet side. I've verified that the CAT5 cable, port and Access Point are in good working condition. Could it be a ...

I have an Aironet 340 Bridge which recently stopped functioning with the following symptoms:1. The ethernet light is steady amber (even when disconnected, and the 10BaseT lights continue to flash when disconnected).2. The status light is steady red.3...

May I use an Aironet 802.11a/b/g card in a Lucent AP-3 (access point 802.11g)?

All clients are unable to do LEAP authentication after a ACS 3.0 upgrade. On the ACS error message is Radius Extension DLL Rejected userOn the AP error messgae is Failed EAP-Authentication Using External Database to WIN2K Domain.

I bought 2 AP1231G (802.11g) last week. And I tried to install them in our office When I use my notebook with 802.11g Wireless adaptor , the connection between AP1231G and my notebook is normal But when I use 802.11b Wireless adaptor , the AP1231G ca...

Hello,I have an ethernet network with a Win2k domain and what I would like to do is convert a few of the rooms to wireless. I'm not sure what I need to do to get started. I have looked at the US Robotics website and they have something called the Net...

Please help a rf beginner:1.Can the rate between AP and client been shiftet (e. g. from 11 to 5.5 mbps) during the transmission of a frame? Or only between two frames?2.How does an AP recognize the sending speed of an ap (and vice versa)? Do both use...

I have eight Cisco 352/342 bridges and access points in a network. These see a lot of transient traffic and connections and as a result, there are a lot of "unassigned" listings in the table that stay there for a long time.Is there some way to "dump"...

Hi folks,I have a Cisco1100 infrastructure but have lots of Dell Laptop users with Truemobile 1300/1400's. We want to authenticate these users using PEAP against the Active Directory. The 1100+PEAP+ 350 Cisco client adapters work a treat but the Dell...

When you upgrade the AP1200 from VxWorks to IOS, the upgrade process changes the SNMP Read-only string to "public" from whatever it was earlier. Anyone experianced that before. Please help!