Wireless

Hello,I have the following situation:- Cisco AP1121G (with IOS 12.2(13)JA1) that connects in the wired side to a HP Procurve switch 2524.- 3 VLANs: Management (20), Staff (100) and Guest (102)- 1 PC connected to the wired network- Wireless users that...

Dear Sir,Does Cisco have the road map of IEEE 802.16 in mind?Thanks.Regards,Delon

Hi There,I think I can use TKIP+WEP without EAP or LEAP, under WEP Encryption there is a box Enable Per Packet Keying. I think this is TKIP but I'm not sure, Is it?If so is PPK original TKIP or CKIP, because as far as I know TKIP should change keys e...

With LEAP, a session key is used. Cisco docs point out, that after the authentication phase, the session key is distributed from the RADIUS Server to the AP and Client.Does this mean, that the session key is transmitted in cleartext?I would be very h...

Hello,Has anyone tried using the WLSE Security Policies? There is no information in the WLSE User Guide as to what configs they check. The Policies are checked via SNMP. By doing a tcpdump of the WLSE traffic I've managed to figure out which OIDs the...

I have a 350 bridge and am trying to utilize it to connect a site with their wireless ISP. The ISP has given me one IP address and I wanted to place that on the Radio side of the bridge and a private network on the ehternet side of the bridge and be ...

We have just installed 2 350 Bridges about 150 yards apart. We are experiencing some throughput issues. The thing that bothers me, if I ping the bridge that is plugged into the wired side from a PC that is plugged into the wired side, I see a large f...

helloWhen i order a 1100 AP with this ref: (AIR-AP1121G-E-K9), do i need to order the power supply (AIR-PWR-A=) supparently ? or is it shipped automatically with the AP?

Hi, We have a setup of around 15 Nos of AP1200 running IOS 12.01T1,with 802.1x - PEAP enabled. The problem we are facing is when we do some changes in configuration like adding a new vlan on one AP and try distributing the configuration using the Dis...

We have several 1100 series access points with multiple ssid/vlans configured on each. We have not been able to get any of our clients to connect to a non-broadcast ssid regardless of the security settings, as soon as we change that ssid to broadcast...

I have an aironet AP that is atleast 3 years old. I just bought a Netgear Wireless Router. Will thie Aironet AP be able to connect with my Netgear router within the same wireless network?

Hi,i have ap1100 with the latest ios version 12.2(13)JA3,i think that there is a bug with this version and the older version too...when i query with mib browser .1.3.6.1.4.1.9.9.273.1.1.2.1.1.1 i get a big number.(4294967295) instead of the actual nu...

Have to setup a Cisco AP1200 or 1100 to work together with Nokia D211 Card. Have tried almost everything, but nothing seems to work.

Am I correct when I read that only the AP-123x model of 1200 APs are h/w ready to support 802.11i/AES when approved? Upgrades or replacement will be required for other model 1200s?

This is the thing.I need to connect 150 PCs in a new building which is 25 mts away, those 150 are in the same floor.[How many AP's (aironet350) should I use for those 150? Considering that all those 150 could be in use at the same time.I cannot use w...