Wireless

I have 2 sites that use point-to-point 350 bridges. I have the non-root bridge setup to use leap, MIC and TKIP. The bridges work fine most of the time. but periodically they stop passing traffic and I cannot ping or web to the non-root bridge. When I...

On an AP1220 w/IOS 12.2(11)JA1, all traffic is blocked when an ACL is applied on either the RF interface or the FastE interface, even explicitly permitted traffic. Also, using the "log" command after an ACL line fails to log anything. Below is the AC...

Hi All,Need some technical feedback on whether WLAN solution is suitable for Ip multicast networks. I am currently using novell netware 6.0 which is purely uses ip multicasts for client/ server applications. The network setup comprises of 6 novell se...

I've got a network where I'm using a BR350 as a repeater. Every once and a while about every two weeks or so this bridge will disconnect from the root bridge dropping off all of the repeater's clients in the process. The front panel LEDs indicate no ...

I tested the AP350 IOS converstion program on a BR350 by creating a config and that part worked. And I know that the firmware for the AP's and BR's and the same, so I assume I can use the utility to upgrade my BR350s. But I thought I would ask to mak...

Looking to mount this on a roof. It will be approx 3 feet off the roof surface. There is about 40-50 feet of roof surface in front of this bridge. The other bridge is across the street about 200-300 yards away (max). That bridge will be mounted on th...

Does anyone have or know of an all-in-one guide to getting secure 802.1x wireless working with non-cisco cards please?I have been struggling for weeks attempting to get this working with a Compaq TC1000 tablet PC with built in Compac Mini-WIFI card a...

Hi,I'm looking for technical documentation, newsgroup.Any help will be appreciated.Do I have to forward this question in an other groupISP ?ThanksPhilippe ~~~

I've been searching two days for an answer to this problem and I have come up blank.I just received a 1220B access point (use to be VxWorks basedbut has been "upgraded" to Cisco IOS.) I can get it workingin open/non-encrypted mode. I can get it worki...

Hi there,Under certain conditions, the IP addresses of the client devices are reported as 0.0.0.0 in the AP association table. When these addresses are at 0.0.0.0, the AP is unable to ping those devices. This condition exists until some type of netwo...

I recieved a security bulletin that reads: "Cisco warned that the LEAP authentication protocol, typically used for RADIUS authentication in wireless devices -- including Cisco Aironet devices, is vulnerable to a classic dictionary attack. A remote us...

Hi,Would like to know whether is there any feature or issues will likely to happen when i upgrade the Vxworks software platform to IOS based?I noticed that after the upgrade, the part number of the AP has not changed.Is there anything else that will ...

Can the 2.2dBi rubber ducky antenna (AIR-ANT4941) be used in a plenum area?

This concerns the 1100 AP I cannot access the HTTP page I can use the IOS. is there a command/switch that turns this function on. New out of the box I can but when I load the script I cannot get HTTP I have review the scripts commands to no avail any...

halloI have some doubts about how QoS works in wireless bridge AIR-BR350.Are the following sentencies correct ?1) there is only Priority Queueing from radio-to-Lan direction.2) I can give priority only to certain traffic from radio-to-Lan.3) I can mo...