Wireless

From reading a posting from August it was answered that the Aironet can not be used as a repeater with a non Cisco AP. Is this the case does anyone know? The documentation I have read on my newly purchased 340AP did not lead me to believe that. Any i...

Can anyone point me to good documentation on enabling ACS 3.2 to authenticate against Active Directory for LEAP authentication. I see you need to install a remote agent, but I do not know what a remote agent is or why one is needed. I am running ACS ...

HiI created 2 VLAN's to apply QoS by VLAN: one with background traffic priority and other with Interactive Video.I associeted some laptops with video streaming in VLAN "video" and some trafic generators in VLAN "background".When i generate the backgr...

Hi all!I have situation: Cisco340 PCI working on a PC under WinNT4 Server with SP3, ACU ver. 4.10.010. Card have IP 195.x.x.y, gw 195.x.x.z. Interney provider's AP has it's own IP 192.x.x.x. All working.I'm moving this card to another comp with NT4 S...

Hello all, Kindly help.My organisation accesses internet using a VSAT and wired LAN. We then added a wireless LAN using aironet 350 bridges and APs, everything was going on fine, until recently when the link became slow. In the course of troubleshoot...

I have some older Cisco Workgroup Bridges but I have upgraded the firmware. I was curious if I could disable access for just specific mac addresses on the Ethernet port of a WGB340. I don't want to have to change anything in the authentication server...

I have recently upgraded an AP1200 to IOS - no conversion just a straight implementation of IOS code - absolutely no problems. Simple configuration with just an IP address, mask, and gateway. I used my laptop on the same subnet, etc. connected to a 1...

When I perform site surveys, I notice that no matter what data rate I select (1,2,5.5,11), there doesn't seem to be any difference in the signal to noise ratio. I'm asking this question because sometimes I want to create 2Mbps cells only, or 11Mbps o...

Since the above mentioned model came without any manuals I'm looking for the default user and passwords to configure the access point. I even did not know the ip but I was able to figure that out myselfThanks in advance

Why does the port that an aironet access point is connected to on a Catalyst 5505 with WS-X5012A blades go into Error Disable mode if you disconnnect and reconnect the aironet AP ?The AP is hard coded for 10Mb/s Half Duplex & the switchports are conf...

Hi, thereI have a question about RF tech.My company is notebook manufacturer.We produce many kind of notebook and include wireless lan card(802.1b).The default wireless lan card is using channel 6.So, We have thousand of notebook in channel 6 at manu...

We have a rather large wireless network in a hospital(voice and Data), seems to run o.k.We are using a vpn to authenticate to the wireless network, and running a program called meditech that the end user uses to chart patient info. Seem to be having ...

Hi,We have a customer with a data / voice need and were thinking about using the new 1400 series bridges.Anyone have any experience using these new bridges with voice and data?For our app, the remote site is only 500 ft. away with clear line of site....

Will TKIP work with AP350's, AP1100's and Dell true mobile cards. Or what is the best security solution for intermixing Cisco AP's with Dell True mobile cards in addition to WEP?Thanks.