Wireless

I have 4 350 series access points, 3 repeaters and 1 root access point. All is working well with the added security, BUTafter around 19 days 2 of the repeaters tell me that they are leaving the "BSS", then i cannot log on the them and when i try with...

Hello,I have a 10 nodes wired LAN about 100meters away from my wireless LAN and I wish to access the Internet through the wireless. Can I connect the wired LAN through an AP or must I use a bridge or workgroup bridge?Thank you.Chafe

Does anybody have experience with this security standard? We have a combination of mobile vehicles and fixed sites on a test grid. All are using either BR350's or WGB350's. We have 3 towers with one tower accessing the post LAN. All towers are using ...

Hello all,I'm new to Cisco gear, so I could use a hand. I have a MacOS X 10.2.6 PowerBook and a 350 series PC Card WLAN adapter. The access point I am trying to authenticate to uses Peap. I have the latest drivers for the 350 on the Mac, but can't se...

Hi,I have a VPN concentrator 3005 and a wi-fi environement secured using ACS (LEAP).I would like to set up ipsec on top of LEAP.Anyone has a good documentation on IPsec implementation in that case?thanks.

Can a 350 Bridge support multiple VLANs over the same wireless link? I want to trunk a couple VLANs over a wireless link and need to use 350 bridges to do it. From what I have been reading the 350 can do this, but you need to use one SSID per VLAN.Th...

In a large high school setting we have 15 Aironet 350 series access points installed. We connect to the WLAN using about 200 iBooks, both OS 9 and OS X. We need to address security as we have reports of unauthorized access from outside the building. ...

Here is an issue encountered when using Pix 501 firewalls to protect an internal network from a WLAN. The WLAN is a number of hubbed Linksys WAP54G units. Mobile devices are Symbol 8146 PDTs running PocketPC 2002 - these have built-in 802.11b network...

I have a BR350 that is acting as a repeater. Every once and a while (with increasing frequency lately) the radio just stops passing data. I can't associate to the wireless side, and I haven't tested access from the wired side.When the radio "goes stu...

I just finished settiing up a wlan with 10 APs and a cisco 2950 switch. I know cisco states mix cells are not very secure but security is not a major factor. I tried to implmet mix cells with the WEP optional command but my cisco 350 clients won't co...

Due to all the viruses that were going around the last coule of weeks we had to send out numerous hotfixes and patches via Microsoft SMS. I noticed on some of the wireless devices(tablets, laptops, desktops)that are using the 350 PCMCIA/PCM cards, th...

Would appreciate some advice. Access point no longer shows any indication of receiving power. Could AC adapter only be fried or is the whole unit likely a goner? If the former, how best can I get a new adapter to try? If the latter, is it worth sendi...

I have been trying to upgrade some IBM T20 laptops running Win XP SP1 to support PEAP. The laptops have been operating without security and had the ACU loaded. Once the ACU is upgraded to 6.0, drivers to 8.30 and firmware to 5.20. from CCO, the setup...