Wireless

I am facing a problem with my Wireless setup,It was working fine but all of a sudden from past few days iMy clients are not getting authenticated , When i see the logs on the Access Points i c the message "EAP retry Limit Reached for station XXXX" St...

I know I can authenticate repeater AP, but I don't if I can authenticate users who try associate with repeater AP ?? So I have root AP which is wired connected with RADIUS server (through switch) and repeater AP, and I want wireless clients to authen...

I installed a wireless network using CISCO AIRONET 1200 APs and presently accessing AP through Internet browser using plain text password. I would like to know if there is any way I could implement TACACS+ authentication to get access to AP. Thanks i...

I am trying to find what vendors wireless cards will work with the Cisco 1200 access points that will be using an ACS server to authenitcate. I know that the Aiport Extreme and the Linksys WPC55AG supports LEAP.Does anyone know of other vendors that ...

I've recently installed WLSE 1.3 and upgraded to 2.0. On both versions I'm not receiving snmp traps from the WLSE on my network management system.Syslog is working a treat.When viewing the ADMINISTRATION->Appliance->snmpd.log I get the following outp...

I need to configure another repeater hop to the root , I already configured the first repeater and its working fine , Is there any special configuration for the secound repeater , note that the parent I use for the secound repeater is the first repea...

Is it possible to configure an Omnidirectional Bridge Antenna as Directional.Actually my customer has connected two of his sites using AiroNet 350 wireless bridge at both ends. One wireless bridge has a Directional Antenna, and the other one has Omni...

Greetings,In the 1200AP Documentation, there are several references to CLI. If I console into the device, I get a menu driven interface.How do I get to the CLI?Thanks

On of my customers that has a fifty bridge node metro area network is interested in a maintance contract. I'm wondering if anyone has a contract along these lines that they could eMail/fax me, or any pointers on things that should be covered in the c...

Hi,I have a customer's environment that use Catalyst 3550 switch at the edge. They are using L3 forwarding. No L2 or spanning tree is running at their environment. Therefore, Mobile IP needs to be implemented to enable L3 roaming instead of L2. a) Do...

Could anyone suggest the best way to avoid the interference to the wireless network from an outside wireless network. When a sniffer was connected these networks were found to be operating under different channels but we could see interference from t...

We've been noticing lateley that the forwarding state on the internal and external radios is 'Blocking' on some access points and 'Forwarding' on others. All of the access points are basically configured the same with the same code (12.03T) on them (...

We are working to install 3 floors worth of wireless in our office building, Which AP's would be the recomended ones? From what I take, the only differance between the three is upgradability. Is this correct?Thanks

I am not too familiar with Cisco's CLI. Does any body know of a good website\manual that gives the basic of how to use the CLI and the commands?Thanks