Wireless

The AP display this message as I "boot" up to the main menu.Motherboard: MPC860 50MHz, 2048KB FLASH, 16384KB DRAM, Revision 21Bootstrap Ver. 1.01: FLASH, CRC AB31F5C0 (OK)Initialization: Improper Motherboard ConfigWhat can I do to recover the AP

I have few 350 series clients that are working with 1100 series AP that keep dropping connections then re-connecting. Some of the PC are running XP and other Win 98. It is not the AP because I have other users that ate connected and have not issues. ...

I just read a brief reference to a 3rd Party Company hired to crack TKIP and MIC using passive & inductive hacking methods that were used to crack WEP. The tests came back that Cisco enhancements were solid and couldn't be cracked. Can anyone please ...

the title says it all.thanks

I have two 350 bridges running approx 2/3 miles with 21dbi yagi antennas. The uplink is continuously dropping with no pattern showing. The 350's are running the latest version of code. Tried with and without encryption, tried with the beacon rate at ...

AP 1200 doesnot boot up. When I tried to boot it up, it gives the following error: "The system unable to boot automatically because there are no bootable files to boot." Than it displays the software version of the AP and Cisco contact info. After di...

Can you use the Aironet 1200 box with 352 client cards and succesfully authenticate to an ACS v2.6 server?

I have a user that is running windows me. I installed a 350 series wireless PCI NIC and it will connected and then disconnect for the AP. I have changed out the NIC, changed PCI slots, updated drives, ACU and firmware on the NIC, but nothing helps. I...

Hello,I have a laptop with WinXP and Linux installed, last week, I update the drivers for the Cisco Aironet 350 cards from MS windows-update.Now everytime I use a card on WinXP then it never works again under Linux.Windows Aironet driver version is 8...

Whilst running WinXP with a 350 PCMCIA attached, I inadvertently installed Microsoft Upgrade 815485 (WPA Update) and have since been unable to Associate albeit for 5 seconds following card insertion. Roll-back recovery proved that the MS upgrade caus...

HelloTwo monts ago we installed two BR3500 succesfully. One as a root and the other one as a non-root BR, there are parox 400 metters between each BR and no fhysical interference. But since last week the end users in the wired Lan in the non-root BR ...

I am currently using spectralink WLAN phone with Cisco AP1200/350,I found audio would be dropped. It is caused by spectralink phone would re-authenticate/re-associate AP many times in a short period time, Every timeit would casued audio dropped.Any o...

HellloWe are using LEAP with CSACS internal user database to authenticate our wireless users. We are using the latest ACU from Cisco and for some reason when we start the LEAP auth process, it takes up to 3 minutes on the finding domain controller po...

Helllo We are using LEAP authentication with CSACS internal user database to authenticate our wireless users. We are using the latest ACU from Cisco and for some reason when we start the LEAP auth process, it takes up to 3 minutes on the finding doma...

I have two buildings that are ~1 mile apart that I was looking to connect via Aironet 350 bridges but these two buildings are seperated by a natural hill so there is not line of sight. I can stand at the top of the hill and have line of sight to both...