Wireless

Hello,I have a point to point wireless setup, using two AP 340's. I have the root set to bridge only, and the other end set to client. Is this correct, or should both be set to bridge?Thanks for any and all help,Jeff

Hi,the german RegTP has released the 5 Ghz frequency band.Do anyone know when the AP1200 with 54Mpbs (ETSI) is avaiable in germany inclusive the pc-cards/pcmcia-cards? If already available what ist the product number? If not, when cisco plans to offe...

I have loaded a 350 Series Client card into a HP Vectra PC. I previously had Version 4.13 software loaded on the PC with the old firmward for the Wireless Card. I updated the software on the PC to Version 5.05 as well as the firmware on the card. The...

I have a client that insists on using the hp wp 110 wireless print server with our Cisco 1200 APs. We use the block PSPF setting for various reasons. I cannot make his print servers work unless I toggle the PSPF setting in the Associations Advanced s...

Is it possible to hide the SSID and Network Range from a client running a wireless sniffer with the adapter in monitor mode ?

Does the 1200 have any SNMP OID related to the DC volts it's receiving?We're running on a solar powered system, and need to be able to monitor (and trigger alerts) if the voltage gets too low.Been trying to find affordable voltage monitors that are S...

Even though encryption is enable on both the Root and Repeater AP's, we're still getting farily frequent error:Station [AP22]000785b3362a Associated with Encryption, then attempted to send an Unencrypted packet to [ap13]000ab7af3095 (length 92) a few...

I can track traffic on the ethernet port and the wireless port of the AP, and even the "repeater" port of the same AP (is that the link with our repeater I assume), how can we output for MRTG type use, how much each IP/MAC is using, via SNMP? When vi...

Though the right servers are setup, and accessible to all our clients, both the Root and Repeater AP's keep reporting they can't access the DNS servers:Repeatedly failed to connect to DNS Server. Temporarily DISABLING DNS lookups for 5 minutes. To im...

Hello!Does anyone know what is the maximum length of UTP cable between the 350 Series Wireless Bridge, AIR-BR350, and the power Ethernet adaptor.The adaptor receives 220V AC and transmits 48V DC through the UTP cable to the bridge, the question is wh...

The wireless diagrams with the antenna documentation is confusing. It left me with the following questions:1. If you were using an omni-directional antenna (say AIR-ANT5959, for example) and have the antenna facing down as if it were attached to the ...

All our bridges and access points and clients use the same open authentication with static WEP key. Short of deploying a custom configuration for my bridge connections, is there a way to prevent clients other than bridges in client role from associat...

Has anyone had success placing a 350 NIC into monitor mode on RH 7.3 Linux? I've tried setting the mode to "y" and "r" in /proc/driver/aironet/eth0/Config , but it always magically places itself back into "ESS". I have the latest version of the drive...

http://wlanresearch.com/LEAP_AIrFortress.htmAll types of comments are welcome!Thanks,Audie Onibala"The best way to move-up is to make a stand, and learn from your mistakes"

Hey folks. My boss had just given me the task of testing out a wireless enviroment. He was looking to setup a wireless network that authenticates to our active directory windows 2000 server. The hardware/software i am using are Cisco 350 PCMCIA Serie...