Wireless

We're a very small rural Wireless ISP.Having some very strange routing/bridging issues.We have the following setup:Router .1 (IP)Netgear ME102 in Point to Point (.11) to (via pair of 19 Dbi parabolic antenna's withing 1 mile of each other) Cabletron ...

I currently have about 75 AP 350's at all of my locations. I am currently running LEAP but it is restricted to 350 nic's only. Our company has decided to buy laptops with built in NIC's (true moble) These will not work with LEAP. Will i be able to so...

Hello, is it possible to use Symbol spectrum access points with ACS server 3.1?The only problem I could see is during network configuration, you need to put in the client and associate using some type of Cisco authorization (IE: Cisco IOS, Aironet). ...

Hello,I just purchased and setup a Cisco Aironet AIR-BSE340 Base Station. I am connecting to it with a Air PCM 342 card in my laptop.Based on this article:http://techupdate.zdnet.com/techupdate/stories/main/0,14179,2693413,00.htmlI would like to try ...

The MIC is based on seed value destination address source address and payload.Can somebody help me out with the following questions:What is a seed value ?How is the seed value determined ?Thanks,Michel

Does anyone know if Cisco wireless products (AP350 & AP1200) prevent wireless clients from registering and participating in multicast events?

I have tried to relocate a document that I saw on cco about 6 months ago on how to use the variables for the AP340, AP350, and AP1200 to create a config script that you could upload as an .ini. Does any one know how to do this or where the document i...

which is the procedure for configure the equipments?

Hi all,I am soon to undertake a security review of our 802.11b network which uses a mix of Aironet 350 and 1200 APs and 350 pcmcia cards.I have read conflicting reports regarding which cards can be used with which programs... I would ideally like to ...

Does IOS image c1200-k9w7-mx.122-8.JA install to AP1200 ?

Can I use the bridge as repeater?Can I connect two antenas on aironet bridge 350 and use it as repeater?Thanks,Norma

Hi there,I was wondering if anyone has suggestions, guidelines or just rules of thumb in performing a site survey. What tools do you normally use, and what methods do you use to test your setup once it has been deployed? Thanks.

Okay, here is a quick question. How is the best way to calculate vertical beam width for wireless antenna's. Here is an example. Let's say you have a 12db OMNI with a 7 degree V beam width. It's mounted on a pole 100' in the air. .25 miles away we ha...

Hi.Is it possible to upgrade an AP 350 to higher datarate than 11Mbit/s?RegardsJimmy Larsson