Wireless

Hi,How to monitoring latency between two wireless points (WWAN)?I would be grateful if you advice me.Best Regards,Mehrdad

My company where i work for, we have licence for broadband fixed wireless access for Indonesia at 28 Ghz and 58 Ghz. Can anyone help me for solution: include instalation, hardware, software. Because we don't have any idea for that, we only have the l...

We have about 6 aps in a baggae sortation room where 2 ap are on different switch, the clients use scanner that just talk to a web page, they complain about the internet explorer e just spinning, what I found out was that I had to adjust the cell siz...

Hi All,recently installed the AP 350, and can work properly. But today, I cannot see the status of the radio, only ethernet port is UP.Therefore I can't use the wireless client card at all. No signal at all.How to solve the problem?TIA,Andi

I have a demo WLSE that I upgraded from 1.1 to 1.3. For the many switches it discovered along with APs, it is declaring for each of them : "Switch memory utilization is Degraded (66%)" -or some other percent. Is this a glitch? Anyone else seeing this...

Can the Cisco Aironet 350 run NAT?

Is there a way to change the 350 MiniPCI client MAC address in XP or with the Aironet utilities ?

Hi, my APs are directed to send snmp traps to the netview system. And when a wireless lan user gets onto the lan successfully, the corresponding AP would send a message similar to the following:Thu Dec 12 17:19:05 2002 "APhostname" Trap found with no...

I am getting the following message in the log of a few of our 1200 series access points. Network Bridge Loop: Received packet from Self destined to [AWC Mcast AP-Only]014096ffff00 on port "emac0"What is causing this and what can I do to prevent it fr...

Need Help, I was unable to assoc to AP which firnware 12.00T ot 12.01T with client have this version of firmware 4.25 , What is the meaning of this Require use of Radio Firmware 5.02L yes/no, ThanksRegardsMCNaz-yeo

Will the "Bridge Spacing" feature of the 350 Bridge help in reducing collisions for a 2000 ft radius outdoor Access Point. Any other suggestions to help make this work? We have a central 40 ft high 8db omni antenna and each laptop is using an LMC352 ...

how can I configure certificates (PEAP) on AP350, clients? I need samples the configure

Befor about 9 months I installed 20 sites Linking to 2 Omnis in Diversity mode in a 6km radius and the network was working fine with WEP enabled using 4.25H firmware, when I added 5 more sites (using 4.25G Firmware) the Root bridge started to reboot ...

How can I find a way to use my laptop without all the wire . I want to use it anywhere at home, or on the road and be online