Wireless

I am having an issue with 350 workgroup bridges and AP1200's getting CRC errors and dropping communication. Any idea where the CRC error's could be coming from?

Hi! I`ve problem with setting up a trunk between a L3 switch (4006) and a Aironet 1100 AP. Below are a description of what I want to do: I want to set up a wireless network, running together with our wired network, which uses the same VLAN`s as our w...

I'm new in wireless, and my boss force me create an wireless solution for a big meeting hall. It's is a big meetting hall with 40m long, 20m width, the requirement is 50-60 laplop can access to data center through wireless. I'm thinking of two 350, i...

Will the 340 point to point wireless bridge authenicate and use Leap if upgraded to the latest software, like the 350 series bridges? The documentation is not clear on this.

Hi,im wondering if i could somehow authenticate wireless users with securID OTP? is there any way of proxing the authentication to securid server? have anyony heard of the internet draft for eap-securid?http://www.globecom.net/ietf/draft/draft-josefs...

http://www.wlanresearch.comLet me know! [email protected]

After struggeling a while with this, reading docs over and over I'm not geting there.We're actively using LEAP on an aironet AP 350, aironet PCMCIA 350 and TACACS+ 3.0.Now we want to use the Aironet 1120B AP with same server & adapters in the same le...

We're a very small rural Wireless ISP.Having some very strange routing/bridging issues.We have the following setup:Router .1 (IP)Netgear ME102 in Point to Point (.11) to (via pair of 19 Dbi parabolic antenna's withing 1 mile of each other) Cabletron ...

I currently have about 75 AP 350's at all of my locations. I am currently running LEAP but it is restricted to 350 nic's only. Our company has decided to buy laptops with built in NIC's (true moble) These will not work with LEAP. Will i be able to so...

Hello, is it possible to use Symbol spectrum access points with ACS server 3.1?The only problem I could see is during network configuration, you need to put in the client and associate using some type of Cisco authorization (IE: Cisco IOS, Aironet). ...

Hello,I just purchased and setup a Cisco Aironet AIR-BSE340 Base Station. I am connecting to it with a Air PCM 342 card in my laptop.Based on this article:http://techupdate.zdnet.com/techupdate/stories/main/0,14179,2693413,00.htmlI would like to try ...

The MIC is based on seed value destination address source address and payload.Can somebody help me out with the following questions:What is a seed value ?How is the seed value determined ?Thanks,Michel

Does anyone know if Cisco wireless products (AP350 & AP1200) prevent wireless clients from registering and participating in multicast events?

I have tried to relocate a document that I saw on cco about 6 months ago on how to use the variables for the AP340, AP350, and AP1200 to create a config script that you could upload as an .ini. Does any one know how to do this or where the document i...

which is the procedure for configure the equipments?