Wireless

I have been using the Cisco Aironet 350 wireless pcmcia card with my IBM Thinkpad T21 running Windows 2000 for several months now. The adapter still works, however I now have an annoying problem with ACU. Whenever I reboot my machine, I have to go in...

We have Cisco 350 Work-group bridges. We have successfully fed a shared hub with this device, but the connection is not very reliable. Is it possible to have a 350 feed a managed switch?

Hi,How do you configure this? Don't seems to get this working.Pls help.

I have a outdoor wireless link bridge-to-bridge. the distance between the sites is 8 km. the power level of the link is 51% (trans.) 56% (recep.) quality of signal is 70% (out) 76%(in). the line of sight is perfect.My problem is, the bridges loose th...

Does the current Aironet 340/350 drivers for Win CE support 802.1x?

I have set up a 350 AP with 252 PCMCIA clients running Win2k prof. I am using ACS 3.0 running on an 2000 member server and set up for authentication against the Win2k domain. However, clients cannot authenticate. In the failed attempts log on ACS I g...

Hello,As a weekend project, I tried connecting an Aironet 350 series pcmica to a 350 access point, but continually get the above message. I get flashing 'Status' and 'Activity' lights. I know that there is some kind of communication, because when I g...

Is there a way to configure my routers to use a 56k serial link as a backup to my wireless ethernet bridge? My problem is that when the radio link fails, the interface on the routers don't actually go down. My remote end was forwarding on Eth0, block...

Does anyone know if the AIR-AP1200 comes with an inline power injector unit included, or must they be ordered seperately ?

One AP is "serving" 20 users in channel 1. Bye adding an AP with the same channel, same location, will I be able to handle more users?

We have Lucent Orinoco PCMCIA cards in our laptops and have just purchesed some Aironet 350's, they work ok with the Orinoco drivers and client manager software,but i can't get the Cisco client ACU software to recognise the cards as i want to get the...

I have setup my routers to allow only SSH (not telnet) access.This is my setupip ssh time-out 120ip ssh authentication-retries 3!!!line vty 0 4login authentication LETmeINtransport preferred sshtransport input sshI am only able to SSH to any router, ...

Hello,I wanted to know whether Cisco Supports voice over wireless.Thanks.

Hello,The objectif is to replace the WAN connection (Serial) by Wireless connection via ethernet. I suggest to add a new module Ethernet in the same router and to pass with wireless equipement such as BR350. Altought, I will have 10Mbps in tne WAN co...

A couple of months ago, I installed three Aironet 350 Bridges, each connected to directional antenna via LMR400 cable. The directionals are pointed towards an access point at the front of the campus. After abou 36-48 hours of use, the ethernet ports ...