Wireless

I'm looking to get into wireless networking. Starting next semster I will pick up some general books about wireless but I wanted to read up on some Cisco too. I've been searching all over for a Cisco Wireless Certification and Cisco books on wireless...

Hi,I have two ISA based 340 series aironet cards. Recently, I have started to upgrade to more modern systems, but I cannot use the aironet cards because all of my new motherboards require PCI cards. Is it possible to purchase new PCI carriers? I woul...

My 350 pcimcia card does not recognize my 4800 access point..my 340 card works fine.

I currently use a Cisco AIR-LMC342 PCMCIA and the Cisco "Rabbit ears" antenna to connect to the 802.11b Internet provider in my area. I want to up grade to a better antenna mounted outside the passenger compartment.Questions:1. What mobile antenna pr...

We are having problems with our RF scanners that use 340 DOS drivers. They get disconnected from the HOST 3 or 4 times a day. We have 350 AP's for our wirless backbone. We also have laptops (running win2k)using 340 and 350 client cards and we never s...

When I try filtering IPX on our AP 350, clients cannot get DHCP properly. When I remove the Filters it works fine. The hope is to keep the radio free from IPX broadcast to inprove throughput. However it seems I am killng the AP. The AP is connected t...

Hello all, We're doing some testing of wireless networks here at my site. We have jumped on an all Cisco solution for now. For the sake of testing we are running 3 different configs using the following hardware:Cisco Aironet 350 APCisco Aironet 350 W...

Is is possible to run four Aironet 350 access points off a small hub or non power switch with an uplink back to a cisco switch if the access points are using the power supplies to get power?

Hello I am sending you the following configuration the CISCO 2651 router. The problem with our router is that last night many times the light was fluctuated and our UPS was not working, becasue of that now the configuration we made on the router is n...

I have a 342 AP that will not allow me to set it for AP/Infrastructure mode - it wants to revert to Survey Client at every boot.It's running 4.25 and 11.07 - what am I missing?

I read a Ciso presentation which stated that a 802.11 bridge could range 25 miles at 1 Mbs, but at access point could only go 1 mile at any data rate. Why is this if the power output is the same? Is this just based on the assumption that you would us...

How do I configure the aironet 350 AP and Airport to connect to my provider's(Verizon DSL) PPPoE connection?The airport sees the aironet access point. But I can't enable the PPPoE connection. The web interface to the aironet configuration shows up. S...

I have a few questions:Do I have to use aironet bridges at each site plus adequate antennas to reach a point-to-point (multiple points, linear) range of more than a few miles (each segment)? In other words, would it work and is it the only solution? ...

we have a centrally located 350 ethernet bridge that I am trying to connect to from a 340 eorkgroup bridge.The association is happening and also the WEP but I cannot ping past each unit. I can ping from one unit to the other but not to a device on th...

Hello all,