I want to know what are the new features or devices or any new technologies for wifi in terms of AI?
Forum Posts
I want to know what are the new AI features in Meraki which I can implement to improve the wifi network as well as new setup which would have in a manufacturing company?
Labbing with a 9130AXI-B EWC and I am unsure what is causing the issue I am seeing. Running 17.12.4.Wireless Clients ---- EWC-AP "employee" PSK SSID --- C3850 --- Firepower ASA --- InternetWired Clients ---- C3850 --- Firepower ASA --- InternetAll VL...
Trying out the Sponsored Guest Login.I am wondering if there is a way to see the email address of who approved the request.Since we can only enter a sponsor email domain, we cannot limit who within that domain can approve.We would like to see who is ...
C9800-40 17.12.x, C91xx local mode, EAP-FAST authentication to C9300 with a MAB fallback. After some weeks or months some APs failed to authenticate themself to dot1x secured LAN. Typicaly after an upgrade some APs are lost. ISE reports: Event 5440 E...
Hello,I'm running Cisco ISE 3.3 with CWA for Self-registration guest portal. When a guest connects to the SSID, they receive the error below. I followed the https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers...
Hi guys,I am configuring from scratch 9800M controllers (SSO pair, which will replace current 5520 pair) and I am assembling RADIUS configuration.Right now, we have Cisco ISE running as RADIUS servers (3.1) for 802.1x wireless and Guest access as wel...
One of our locations run all MR56 AP's on v29.5.1 firmware, and it has been so for many months. The wireless network is tied to a template which defines all SSIDs and settings. One of the SSIDs use 802.1X auth against RADIUS service running on our Fo...
My Access Point is (AIR-AP2802I-S-K9)
I configured eWC on my C9120AXI but encountered a problem where the Access Point sometimes joins and sometimes doesn't. Jan 17 14:42:15.989: %SYS-5-CONFIG_P: Configured programmatically by process SEP_webui_wsma_http from console as admin on vty0 J...
Hello, First of all, I apologize for using a translator to post this question. In our environment, when we need to change an AP’s IP address or hostname, or join it to a new controller, we usually connect it to a test WLC to make the changes before d...
I am attempting to enable the FortiGate captive portal for our Cisco Guest Wi-Fi. Specifically, I have created an open authentication SSID called "Guest" in the WLC. I would like users who connect to the Guest SSID to be automatically redirected to t...
Resolved! 3802i-B-K9 APs not joining ME WLC
I have 5 Cisco Aironet 3802i-B-K9 Access Points. One of which is configured for ME with version 8.10.196.0. The other four I will be using in CAPWAP mode. They are appearing in the Web UI, but for some reason they will not join. I've tried upgrading ...
Wireless clients are experiencing difficulty transitioning from the quarantine VLAN (192.168.40.x) to the Production VLAN (172.22.x.x). Users often need to forget the SSID, toggle their Wi-Fi off and on, or restart their devices before they are succe...
Hi,When ISE posture compliant check is enabled in ISE users on wireless experiencing problemsThey stuck in quarantine subnet and dynamic IP change to their IP doesnt happen, after many attempt it might works, when this happen ISE Posture status on la...
