Hi,We have WLC 9800 with different APs connected to him, last night we upgraded it from 17.3.5 to 17.3.6 for some compatibility reasons with 9130axi to add some new APs, so far everything was good, but after the upgrade, several access points from t...
Hello,We have a Cisco Catalyst 9800-L Wireless Controller in version 17.3.4cI'm looking for create 2 WLAN (same SSID) for the same VLAN:- WLAN broadcasted for location A -> VLAN 2- WLAN no broadcasted for location B -> VLAN 2When i try to use the sam...
Hi all,is advisable to mix different access point types in same enviroment?In my case MR46 are already present 2xfloor and i'd like to add 2xfloor CW9166 or CW9164.thanks for suggestions.Regards,MG
During the cases in which certificates (MIC/ SSC) of either WLC or AP get expired, all APs are not able to join WLC. So we use below commands on WLC. These commands just magically let all the APs to join the WLC (after checking licenses of APs on WLC...
hi,i am configuring the anchor controller for guest.referring to Cisco Doc "Configure WLAN Anchor Mobility Feature on Catalyst 9800".it states on the anchor, the guest WLAN profile must be the same like foreign.Also it states the Policy profile on th...
9800-40s running in any configuration (HA, Standalone) experience communication issues with directly connected 4507 VSS cores. I have TAC currently engaged but looking for inputs.The 9800-40 fails to ping the directly connected SVI on the core and vi...
The issue is with wireless controller Mobility Express version 8.2.166 which is configured for guest WLAN. the issue happen user need to access to cisco page of local web authentication page the browser is not trusting the certificate from the virtua...
Hi all, I had some questions regarding on my FlexConnect C9105AXI-K does not able to perform local authentication when remote office was disconnected from EWC C9105AXI-K in HQ. While I had checked on the policy profile and found that the Central Aut...
Hi WLC 9800 does not authenticate guest customers. Any idea or comment to solve this?
Whats the default AP license capacity for AIR-CT3504-K9 - Controller? Do i need to upgrade my controller with LIC-CT3504-UPG before adding LIC-CT3504-1A licenses.
Dear Community, Please kindly need your advices, can Aironet Access Point such as 3501, 2702, 3702 join WLC 9800 series? do they only need buy AIR-DNA License or do they need extend their warranty first and buy the license also? Any suggestions are a...
Hi All, I have setup Telegraf to collect data from cisco 9800-CL on vmware, then send data to influxdb, everything connected and data tables has shown in influxdb but with no measurements in!Anyone has idea if the cloud version support grpc Telemetry...
Hi NetPro,anyone know the below error msg stand for ?AES-CCMP TSC replay was detected on a packet (TSC 0x1C07) received from 001b.7709.0301. your reply will be highly appreciated.regards,Jackal
Hi all, i got the following problem...I have an access point on which we have the site survey modus active.In order to disable it, I would like to connect to the local ap website.Unfortunately I can not get into the config modus of the ap which is in...
Dear All,I have a Cisco 1815i AP with mobility express installed. I've been noticing lately that its transmit power is low (3 dBm) where other APs have 18 and 20 dBm. In addition, coverage area is small.Although this was working normally before, but ...
