Good Day All, I have a 3802 AP running 8.3.143 that will not join a 5508 controller with 8.5.171. Unable to join controller "root certificate is not present" error. Partial logs below Any tips, please? thanks in advance Regards Amanda CAPWAP S...
Forum Posts
Attempting to use existing RADIUS server that authenticates wireless network users to also authenticate management users. Under Security--> AAA-->RADIUS-->Authentication we have the RADIUS server defined and the "Management" radio button checked. We ...
Resolved! synchronization of MSE and controllers
hello I have two controllers 2504 version 8.5.171.0 and vWLC version 8.3.143.0, prime 3.8.1 and MSE version 8.0.150.0, the controllers bind correctly to the prime and I synchronize them through services/mobility services/synchronize services- control...
I am curious as to what I am seeing while monitoring my WLAN and seeing this oddity. I have never seen this before on any other WLAN except Meraki. This appears on my MR36 network, and a customer's MR44 network. If we have an SSID of say, "Business" ...
Resolved! Outdoor Antenna on Indoor AP
I need to install some external antennas in a walk-in freezer. Has anyone used outdoor antennas like the ma-ant-25 on an MR53E? I have found documentation that says the ma-ant-25 is compatible with the MR74 and MR84 but I am thinking an N-type connec...
Hello, I am trying to upload a certificate for web auth and I am having issues to see the whole chain when I prompt the show certificate webauth command. When I connect to the guest SSID I just see the device certificate and not the whole chain so th...
how to configure a Cisco air-cap-3602l-a-k9 to connect to a Comcast router, how to get the GUI configuration tool?
So behind the "cryptic" Title is the following scenario APs in localmode, but since we need to "pick up" some wired mDNS services on sites, one AP at a site is configured as an mDNS-AP (with the proper VLAN and so on).Great. - So far so good. BUT the...
I'm trying to upgrade a C9800-L-F controller from 17.3.3 to 17.3.4c using ISSU.The controller hardware is:cisco C9800-L-F-K9 (KATAR) processor (revision KATAR) with 1702951K/6147K bytes of memory.The software I'm using is:C9800-L-universalk9_wlc.17.0...
I have an interesting observation that I would like community feedback on.Use-case: Cisco 5520 WLC + 1562E RAP + Locally switched SSID According to Cisco design guide, enabling the global option "Backhaul Client Access" on WLC will allow wireless cli...
Resolved! Cisco AP "Bridge"
Good Day, Have a Mikrotik Bridge (AP) connected to the client's WLC. (Static Bridge IP & PSK Configured On Mikrotik) Printer connects via Ethernet to Bridge (Static IP on Printer) Looking to replace the Mikrotik's with Cisco equivalent(s) Asking for ...
How does everyone do their AP / RF grouping for large corporate buildings? Do you do by floor? By wing? etc.
Hi Team, i like to change the AP Mode from CAPWAP to eWLC on 9105w to perform a Site Survey. I upgraded and converted in every known fashion, following the Guides, but the command "ap-type ewc..." is still not available, in no . Now the AP is associa...
Hi all,we have 2x WLC 9800 physical/virtual in HA and notice occasionally switch to/from WLC1 to WLC2, which causes short connection interruption while all APs go to the other WLC.we did upgrade to 17.3.4c from 17.3.2a - same issueios same on both WL...
Hi,Our deployment is currently composed by:- Catalyst 9800-40 release Amsterdam 17.3.3 (upgrade performed from the default version 16.12.02s) - Access Point 9120AXWe are not allowed to configure the helper address on the Gateway (Firewall Checkpoint)...
