Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hi Team,Please let me know which version of 5508 controller supports DHE and ECDHE ciphers for Secure web connection.
We would like to install Cisco Access point . But I'm not sure distance between Floor to Ceiling . In Area Ceiling high 7M I'm not sure Can we install omi access point ? Please advise me for my concern.
Hi All, I've convert the AP-1850 to Mobility Express mode with software Release 8.10.130.0 .And after initial setup, I can access the WLC SSH and can ping the MGMT IP but I cannot access the Web interface both http:// and https:// Below is my settin...
The AP will only need to broadcast 1 or 2 SSID's on a very small network with minimal traffic. I do not have a controller and the expense of a separate controller is not really worth it. We received this device on a grant and it comes with a 1 year r...
Hello, I currently use two AP3702 WiFi access points (model with 4 antennas in POE) with the same SSID, this allows me to have a Wifi network all over my house.Depending on my distance from the access point, my device (Smartphone, tablet...) switches...
Hi I have two certificates (Webauth and Webadmin), created using the WLC's CSR. Both fail to install. Both will TFTP onto the WLC fine using the Upload command on the GUI but fail to install. The logs show: %UPDATE-3-CERT_INST_FAIL: updcode.c:1276 ...
I am confuring a new wireless Bridge. I have already configured one of the AP as the root bridge but when Configuring the second one to be non-root, the dot11radio was in root so then I changed it to non-root bridge. When I checked the radio inter...
I am configuring a wireless Bridge on the AP AIR-AP1572EAC-E-K9. When I, set the role to non-root on Radio and enables it,the status says that the software/Hardware is disabled and down and when I change it to Root and enables, the status is enable...
I'm setting up several wireless controllers for several sites, all 3504s or 5520s running 8.5.161. The 5520s will be deployed in HA at the primary site and will provide wireless for the main site, and all the smaller remote sites (1-2 APs each). We...
Hi All- This is a weird one. The environment looks like this: 5520 controller running 8.5.140. 3702i APs. Spectralink Versity 9553 or Apple iPhone SIP clients. SSID is local. QOS is set to Platinum.Infrastructure looks like this:5520 <- VPC ove...
Resolved! Migration from Cisco WLC 5508 to 5520
Hello everyone, I need to migrate cisco wlc 5508 to 5520. This Cisco 5508 WLC is under production , is it possible I can import the configuration file from this 5508 and export to new 5520. Please provide the steps which need to follow while d...
Hi,I am looking for the procedure to completley default a 3502i AP and reset the username and passwords. It has previously been associtated with a controller at another clients site. All the documentation I have found so far outline procedures for ol...
Is it possible to use Azure AD Domain Service (not Azure AD) as external identity source for 802.1x?
Resolved! AIR-1562e
Can I install one omni and one directional antenna on a single 1562E access point and use the one for 2.4GHz and the other for 5GHz?
Hello, i have 4 cisco 1142 autonomous access point. with Catalyst 3560-X Series PoE+, i need to cover two floors with the same SSID. is one AP as Access point and the other 3 as repeater will be a good solution ? Thanks
