Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi Wireless Control System Navigator is WCS? I cannot find Wireless Control System, but i can find Wireless Control System Navigator in cisco download page. are these two the same thing? thanks
The WLC version is 7.6.100.0 with 75 AP licenses. I have 64 APs. I have 3 APs not joined now. I can ping all of the IP addreses of the APs from the controller. The controller has the correct time, date and time zone.There is other APs working correct...
We have Cisco WLC 2504. How do I get a list of IP addresses of all APs? firmware version? I need export to an excel file.
Hi everyone, I have setup the Mobility Express Controller on AP model AIR-AP2802E-S-K9. The ME work as well, now I am trying add APs to ME Controller, but it won't work. While check log on console, the AP show this fault as below. [*08/17/2021 13:25...
Dear AllOn Cisco wireless AP can support Cellular I saw just meraki product support CellularI don't AP controller base support cellularthank you
Hi We can see default acl configuration at WLC 9800 via GUI (configuration -----> Security ----> ACL), but we cannot see the default acl sometimes. Why this happens? What can control this? Thanks
Are there any roaming issues for voice clients when you have different AP groups on the same floor? For instance, a lecture hall has very high data rates and rrm parameters while the rest of the floor is office and needs lower data rates? The WLAN ...
we have in office multiple switches but the POE connecting to the Cisco Aironet 1832i is a Cisco Catalyst 2960s-48, all was working with little problems / disruption until recently a lot of problems began to show connecting to Wi-Fi for several users...
Hello community, I have an issue with access points IP addresses. I have configured APs with static IP addresses but when I connected the APs to the switch they get an IP address from the DHCP in a different subnet than the vlan APs (because the swit...
Is it just me or is the Cisco CBW 140ac the worst access point? I have a 2 story house and a 140ac(Primary) on 1 floor and a 145ac on the top floor with mesh turned on. The problem with mine is that the coverage is very spotty/flak. If i turn one ...
Hi,We're implementing a guest SSID which will use Meraki Authentication. We're testing now and want to amend the email which users receive. I've looked on the dashboard but can't see where it would be set. Anyone know if this is possible? Even if we ...
Hi All, I wonder if you can help us with a Radius server failover configuration on our virtual 9800-CL. Specifically the 'automate-tester' command on the first Radius Server (ISE): !radius server 1address ipv4 1.1.1.1 auth-port 1812 acct-port 1813au...
Hello Techies, Need help, actually my client want to enable 802.1x security in SSID of standalone Access point for certificate base authentication, we do have radius server in our environment, please help me with the full configuration commands inclu...
Hello everybody!WLC 5508 controllerPlease advize how to more competently monitor a specific access point for falling off clients and establish this with the cause of the failure.Sometimes clients fall off a specific AP, there is an assumption that a ...
Hi, The below is part of output of show run of C9800 wlc . What is that meaning with packages.conf ? Is this normal?Thanks WLC#show running | i bootboot-start-markerboot system bootflash:packages.conf:C9800-L-universalk9_wlc.17.05.01.SPA.binboot-end...
