Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

I have a single AP running mobility express 8.6.101.0 . I configured a second SSID for Guest access. After rebooting the AP I can still access the 1st SSID I was using but the 2nd SSID is not broadcasting. I have verified it is configured to broadcas...

sariel by Level 1
  • 837 Views
  • 1 replies
  • 0 Helpful votes

Hello,   I have one question about CDP for AP. Is this protocol mandatory for AP interface (switch side) ?   I just see cdp is needed for some features as "Port Tracing" for Prime or WLC.   But do we need really cdp for AP (POE or others) ?   Best re...

jean1 by Level 1
  • 820 Views
  • 3 replies
  • 0 Helpful votes

Hello, is cisco wlc 3504 compatible with 1832I? because I have already check cisco 1830 data sheet and above mentioned wlc is not there, please check attachment or link below.    https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-183...

image.png image.png
Jaro by Level 1
  • 3352 Views
  • 3 replies
  • 0 Helpful votes

Hello Cisco WLAN-experts,    we recently applied the following to our Prime:   Prime Infrastructure 3.2.2 Maintenance Release file name PI_3_2_2-1.0.13.ubf   Now we suffer from Long Response times regarding the map application. The heat maps take sev...

There is one switch in Cisco  Prime. But when user try deleting the device from the prime, it is not getting deleted. Getting the below error : "Delete Device(s) Failed:  Please see ifm_inventory.log to get initial information. Please contact system ...

BhaskarDS by Level 1
  • 724 Views
  • 3 replies
  • 0 Helpful votes

Hi, Is it possible to deploy one controller for a company that has branches? Deploy it at the head Office provision the AP's then place those AP's at branches but manage them using one controller at the head office? If yes what should be configured? 

Hi,   I am a first time installer I have installed my wireless controller and it is visible on the network but the APs are not visible on the controller what should I do. When i Console into the AP it gives me Some error msg    Please see the attache...

Hi all The latest WLC releases (8.3.143.0 and 8.5.131.0) state that they follow the new ETSI 301 893 regulation. I have read now into this document (a little), download: http://www.etsi.org/deliver/etsi_en/301800_301899/301893/02.01.01_60/en_301893v0...

patoberli by VIP Alumni
  • 503 Views
  • 4 replies
  • 0 Helpful votes

Hello   I have a problem with connecting one client with static ip to the wlan. DHCP require is disable, passive client is disable. Wlc cannot obtain client ip address:   *Dot1x_NW_MsgTask_0: Jun 18 14:15:39.962: xx:xx:xx:xx:xx:xx 0.0.0.0 DHCP_REQD (...

Hi Could someone help me to inform me that which AP can configure with workgroup bridge because I have plan to connect five sites to the master site via wireless connection. many thanks

osama1975 by Level 1
  • 982 Views
  • 3 replies
  • 0 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card