Buy or Renew
Buy or Renew

XR OS and Platforms

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Take

 

Forum Posts

Start a conversation

Resolved! A9K-RSP-4G v3 - Configuration register on node 0/RSP0/CPU0 is 0x2142

Hi guys, we have noticed  that all the new RMAs on the network for A9K-RSP-4G are comming with the config register set to 0x2142,HD with 80Gb and 1.8 of disk0, same as after reparticion on a 1.5 disk,all the  cards are VID: V03.Are these  the expecte...

ASR 9010 licensing question

Hi,any good cisco reference for installing licenses for ASR 9010 router?we need to "move" license to oper state(admin)#sho license Mon May 28 15:44:08.686 UTCFeatureID: A9K-AIP-LIC-B (Slot based, Permanent)    Total licenses 2  Available for use     ...

MPLS-TE Shared Risk Link Group

Hi experts,How different is the implementation of MPLS-TE SRLG on IOS-XR in comparison to IOS.One of the prerequisites on IOS is that SRLG is only supported for backup autotunnels. Does IOS-XR supports SRLG for backup autotunnels? A configuration ill...

asr9k

Dear Staff,When change RD in Cisco IOS XR Software, Version 4.3.2 to an IP the octets strangely comes not in order i.e:Before: rd 6500:1750After rd 62.1.2.3:1750When doing the sh vrf all appears:3.2.1.62_1750 in output.Anybody has a explanation for t...

narroz by • Level 1
  • 515 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Number of OSPF processes

Hi!I would like to know are there any limitations in number of OSPF processes in IOS-XR, especially on ASR9010 platform?  Active Packages:    disk0:asr9k-mini-px-4.3.4    disk0:asr9k-fpd-px-4.3.4    disk0:asr9k-doc-px-4.3.4    disk0:asr9k-mpls-px-4.3...

HSRP on unnumbered interface with MGO

Should the following configuration work? !interface Bundle-Ether20.2238 description test customer service-policy input input-classify ipv4 point-to-point ipv4 unnumbered Loopback0 encapsulation dot1ad 2238 dot1q 2238!interface Bundle-Ether20.2810 des...

Resolved! CRS-X/16 - Dolly

Hello All,I will have to install a CRS-X/16 in the near future and I need to understand if the "Dolly" (CRS-16-LIFT/B) from a CRS-3/16 is suitable for the CRS-X/16.Thanks.Regards,Pedro

Resolved! ASR9006

Hi Fellows;Anybody Knows what´s the meaning of the next log error: %IP-IP_NTP-5-ALL_CONN_LOST : All NTP peer connections failed.RP/0/RSP0/CPU0:May 19 19:47:32.868 : ntpd[261]: %IP-IP_NTP-5-LP_CONN_RECOVERED : At least a low priority NTP peer connecti...

Leo Monge by • Level 1
  • 1001 Views
  • 1 replies
  • 0 Helpful votes

Resolved! QoS priority in ios-xr

If i configured qos in below way in ios-xr:policy-map test class class1  shape average 100 mbps  ! class class2  shape average 200 mbps ! class class3shape average 50 mbpss  ! class class4  bandwidth remaining percent 90 ! class class-default  bandwi...

Load more