XR OS and Platforms

Hi, I am looking for the ASR9910 chassis layout diagram since is not present on the ASR9000 series data sheets. I would like to know the slots where i should insert the RSP0 and RSP1. Some docs specify on slot 0 and 9, however another specify on slot...

We have a situation with our ASR9001 and BNG setup. Since our solution uses RADIUS to authenitcatePPPoE sessions, each username is limited to 2 concurrent sessions. We have found out that if we clear a subscriber session manually, the RADIUS STOP mes...

Hi, Could you please tell me how to show the mappings between interfaces and FIA on IOS XR ? Thank you, Best regards,   IMA

Hi I'm trying to do an SW Upgrade in ASR903, so I'm receiving a Warning, also the Stby RSP are installed the version 15.6 SP3 and the active not see below:   Wed Mar 14 17:00:29 UTC 2018 Verifying parametersWed Mar 14 17:00:29 UTC 2018 Validating pac...

Hi Experts   What do you make of the below error log? Is it necessary to involve TAC now or any steps to be performed?   prm_server_ty[304]: %PLATFORM-NP-4-FAULT : TCAM interface has a fault on NP 2. Resetting network processor to recover interface  ...

Hi, We performed a turboboot install of 5.3.4 onto an RSP2 line card installed in an ASR9006 without any problems.   However we now repeatedly get the error on the CLI;RP/0/RSP0/CPU0:Mar 13 15:56:51.158 GMT: cepki[162]: %SECURITY-CEPKI-6-ERR : cepki_...

Greetings! Is there a document available for upgrading ASR9K IOS-XR from 4.3.1 to 5.1.3 as well as downgrading 5.1.3 to 4.3.1?

Hi Guys, I read the Installing and Removing Line Cards and Transceiver Modules, for A9K-MOD-160 and A9K-MPA-8X10GE, so just two question:   * Before insert the A9K-MOD-160 is required insert the A9K-MPA-8X10GE module onto Line Card? Or Insert A9K-MOD...

Hello folks,   Does any body could help me to understand the difference between using a using a vfi instead of having just multiples access pseudowires under same bridge domain, is there any difference. I am reaaly intrigue of how it works when i hav...

Recently we will replace one crs-1 and crs-3 chassis with new chassis and rp card， do we need to transfer license from old chassis to new chassis? such as copy old license file from old chassis and install on new chassis?   or if we just replace line...