XR OS and Platforms

Hi everyone,I´m looking for how can I configure AAA authenticacion on ASR9K.I have a TACACS+ serverThanks and regards,Jaime.

Dear all, what is the replacement for continue command in route-map for CRS IOS XR RPL ?is it ? pass command ??actually i had some issue matching almost 15 community attribute ingress from customer network...and i think, is it can be done with pass c...

Hi Is there any similar solution like in Cisco 7600, where you can put in the "ip igmp snooping querier" under the SVI to get the local Multicast feature if you dont need the Multicast routing support more than for the local vlan.So in the following ...

Hi all.I having issue when deploy REP bethween Cisco 4500 Sup 7E/6LE with ASR 9000.Follow the guide http://www.2mul.com/en/US/docs/routers/asr9000/software/asr9k_r4.0/lxvpn/configuration/guide/lesc40book.pdf , page 319 then ASR 9000 work at REP Acces...

hi,Got a question,ASR9k has 2 system HP queue and a default queue, there is no dokument i can find that descripe how packets are mapped into this system level queues per default, from packet enter the ingress interface util the packet leave the egres...

HelloI'm new to ASR9000 and would like to ask the following:1. What's the difference between EXEC mode and admin EXEC mode?  Or simply, when will I need use admin EXEC mode?2. Is there a way to clear the configuration of an ASR9000 (something like "e...

Dear all,Any reason why following config would work on ISO XR3.8.4 and not 4.0.1 ?on CRS-1 running 3.8.4, I a mable to have both IPv4 & IPV6 sessions up. howver on 4.0.1, as soon as address family IPv6 is added, v4 goes down...and v6 has not been abl...

Hi,    We are building a Network with 4 Core Routers,22 Aggregation Routers & 34 Edge Routers.Core Routers                : Cisco CRS-1Aggregation Routers     :  Cisco ASR9000Edge Routers               : Cisco 7609/7613We have a Data Center consistin...

Hello,Could anybody give me the maximum number of MAC addresses supported on the ASR 9000?Thanks

Does anyone know if the ASR 9000 supports Flex Link with Load Balancing like the 7600?

Hi,I have to configure a bfd session between my ASR and a Firewall, over a BGP session.but after configuration i ca't even see the configured session when doing a "show bfd session".by reading some cisco docs, i've seen that BFD can be configured onl...

Hi there, I really don't know how works the netflow over in a bundle-ethernet in CRS. I've got a problem with Arbor peakflow and a CRS, the netfow collector is running in a bundle, but is not configurated in the members of the bundle. Anybody have kn...