Buy or Renew
Buy or Renew
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
2132779members
1463708discussions

Featured Content

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

SDA L2 Flooding Limitations

Hi together,has anyone an idea about the limitations with L2 flooding ?Our customer has a separate infrastructure with lots of L2 broacast domains (~100). This construct ist used for various sensors, terminals, ip-cams, etc...and some devices which m...

5440 Endpoint abandonded EAP session and started new

Hi All,Recently, we migrated our enterprise Wi-Fi authentication method from PEAP to TEAP (inner auth EAP-TLS). Since then, many users have been experiencing disconnections while their sessions are active.In the morning, the Wi-Fi connects and works ...

henokk60 by • Level 1
  • 234 Views
  • 3 replies
  • 0 Helpful votes

IP MAC Binding and IP Source Guard

Hello everyone, Using IP MAC Binding option in Policy Profile is just about creating a binding table for itself or it can be used as a trusted source for features like IP Source Guard? Thanks

QoS in MPLS VPN

Hi,I have some MPLS VPN PE routers. I enabled marking on the LAN ingress interface and shaping on the WAN egress interface that is MPLS enabled.But marked ingress packets do not match on egress MPLS interface.What should I do? 

mmaamm238 by • Level 1
  • 1719 Views
  • 19 replies
  • 0 Helpful votes

HWIC-16A Configuration - Hardware fault?

I'm trying to configure a HWIC-16A as a terminal server without success. I can get a telnet session to connect, but I simply get a blank screen, no data appears to be sent or received over the serial line.The only similar post I could find was https:...

Incoming connections timeout or slow when do connect. isrc1111

i have had the system i have in place for some time and had no problems, when using a 2 router approach [isp1 and isp2] but since i merged both onto 1 device, ISRC111 there is an issue with incoming connections via isp1. i am using the same acl's and...

TheGoob by • VIP
  • 673 Views
  • 18 replies
  • 0 Helpful votes

DS-C9132T-MEK9 - connect datacenters

Hello , can you please tel me if i need additional licenses something like Brocade Extended Fabrics for DS-C9132T-MEK9 switch?  we have to connect two datacanters about 5 km far away from each other

OSPFv3 Interface ID

Hello, everyone. I understand that OSPFv3 separates links from prefixes and purposely moves the prefix information from T1/T2 LSAs into T8/T9. The RFC states the following: o The Hello packet now contains no address information at all. Rather,...

Mitrixsen by • Level 1
  • 80 Views
  • 1 replies
  • 0 Helpful votes

General Health Awareness Discussion

Hi everyone,I wanted to start a simple conversation about general health awareness and how people come across different medication names while browsing online, such as Fildena Double 200 Mg. This is not about giving advice or instructions, just a rel...

Load more