Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2113720members
1452264discussions

Community Activity

Configure Port-channel between to remote sites

I have a question about this — I’d like to know if it’s considered good practice or good design to configure a port-channel between two buildings that are interconnected by two dark fibers. One fiber has a distance of 10.5 kilometers (~6.5 miles) and...

ERTP1 by Level 1
  • 177 Views
  • 7 replies
  • 0 Helpful votes

Mobility Express randomly dropping clients

Hello,I'm facing an issue with our APs dropping clients for some reason. I've examined the logs and I can see it going in a cycle of removing and adding users. We are experiencing this on a range of devices including Android phones and Windows laptop...

Issue with Reverse DNS Lookup only with OpenDNS

 Hello OpenDNS Community,We are encountering a problem where reverse DNS (PTR) lookups for one of our IP addresses succeed on most DNS servers but consistently fail when using OpenDNS resolvers. Specifically, the PTR record resolves correctly on stan...

Quick Contribution Hub

Create a Quick Contribution Hub in Cisco Community to make participation faster and easier. It could include A dashboard of unanswered questions, auto-tagged by topic. Weekly challenges and labs (CML, Packet Tracer, GNS3, EVE-NG) for learning and gam...

gabralve by Cisco Employee
  • 232 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Client per AP

Is there any cisco documentation or what best pratice count of clients per AP? If an AP have 40 clients, can we say this still good?

hs08 by VIP
  • 61 Views
  • 2 replies
  • 0 Helpful votes

Assymetric traffic in between the sub interfaces - FTD

Hi Team, We have an FTD which have an inside interface connect to our LAN switch, this interface is segregated through subinterfaces for DATA and AUDIOCODE vlan and both come under same security zone as seen below.We have both policy and nat rule for...

titusroz03_0-1761629070899.png

Resolved! Fast busy on outbound calls

Hello Everyone,Today I am going through an issue, I have never experienced.We have a CUCM and a 3rd party PBX, we have connected  both the PBXs over a SIP trunk.I have created an Extension 2045 in the 3rd Party PBX and created a route pattern with th...

CBW140AC multiple controller setup separated by VLANs

I need to deploy around 100–200 CBW140AC access points at a single site.Since Cisco’s recommendation is a maximum of 25 APs per controller, I’m considering dividing the deployment into multiple controller domains, each separated by different VLANs. C...

GaeMi_0-1761629960208.png
GaeMi by Level 1
  • 31 Views
  • 0 replies
  • 0 Helpful votes

Resolved! ACI MultiPod IPN using C9500

Hi All,Is it possible to use a Catalyst 9500 switch as an IPN for ACI MultiPod? The Catalyst 9500 17.6 VLAN configuration guide states that this is not supported, however I think that this is only applicable for non high-performance switches as high ...