Buy or Renew
Buy or Renew
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
1999977members
1360588discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

PBR-Route-map match track

I have question about match track please , i have understand ,if track is up ,it execute the follwoed set command ,if down ,it comes automaticaly to the second section of the Route-map ,is my Understanding true please ? . In my Lab ,even if it is dow...

FirePower 1120 (ASA) Chassis Name Change

Dear all,how can I change the chassis name on FirePower-1120?firepower-1120 /system* # set name FirePower-1120Warning: System name modification changes FC zone name and redeploys them non-disruptivelyfirepower-1120 /system* # commit-bufferError: comm...

Azad.A by • Level 1
  • 5 Views
  • 0 replies
  • 0 Helpful votes

Catalyst 9163E Polycarbonate Lid Material and Fire Rating

Hi,I received a 9163E Access Point and with it being an outdoor model I expected the casing to be fully metal. I was surprised to see that the lid is plastic and after removing it states it is polycarbonate and weighs approximately 250g. Its stamped ...

Port Channel issue

CoreSW#sh etherchannel 13 summaryFlags: D - down P - bundled in port-channelI - stand-alone s - suspendedH - Hot-standby (LACP only)R - Layer3 S - Layer2U - in use f - failed to allocate aggregatorM - not in use, minimum links not metu - unsuitable f...

Hybrid Exchange/ SSL Decryption Error

We are in the process of setting up a Hybrid Cloud/ On-prem Exchange environment. We can successfully connect over port 443, but when we try to send emails over port 25 we are getting a SSL Block. We are using the Decrypt - Known Key rule set up usin...

tbduff001 by • Level 1
  • 60 Views
  • 1 replies
  • 0 Helpful votes

Resolved! Update nexus 3k - problem - grub

Hello everyone!I have very bad problem. I can not solve problem with update my Cisco Nexus 3064.Before upgrade I had version: 6.7I upgraded (installed) to nxos.7.0.3.I7.8.binAfter installing and rebooting sw, I saw:    [ 0.000000] Fastboot Memory ...

Full Tunneling stopped working

Hi guys!I have had VPN with full tunneling working for some weeks and suddenly the remote computer doesn't have internet access through the tunnel.I am attached the config file with minor name and outside IP removed for security reasons.Is anybody ab...

StackWise and StackWise Virtual Difference

Hello, I’m new to Cisco and currently studying StackWise and StackWise Virtual. Both technologies seem to reach the same goal for high availability and provide single management interface. I wonder why both exist, especially StackWise is supported in...

Antenna parameters and gain in EWC

Some doubts about antenna gain and parameters in EWC. I can't understand why is so complicated: I have to check which antennas the AP are using (A, B, C, D) and the antenna gain in 0.5 dBi units. Cases:1. I connect an AP C9115AXE with 4 antennas ANT2...

jmprats by • Level 4
  • 104 Views
  • 4 replies
  • 0 Helpful votes

EOL for ISR 892SFP Router

I have been told that the ISR 892SFP router is EOL.  However, I cannot find any EOL notice on Cisco's website that this specific router is EOL.  Please see the following link:Products - End-of-Sale and End-of-Life Products - CiscoCan someone please c...

xzevallos by • Level 1
  • 88 Views
  • 7 replies
  • 0 Helpful votes
Load more